1. Hardware Training
Product: ITMS2

2. INDEX ITMS: Network System Diagram. Mechanical Presentation of ITMS.
Unit Capacity.
SAM2
ITMS (IP Controller)
ITMS System Components
Installation Connections

3.
Harware
ITMS2

4. NETWORK SYSTEM DIAGRAM

5. MECHANICAL PRESENTATION
A – SAM2 Main Controller Unit
B – Alarm Input Adaptor
C – Pix Alarm Output Adaptor
D – Utility Interface Module
E – GSM Modem
F – LCD and Key pad
G – E1 Controller Unit
H – Access Control Unit
ECS2 unit is 2u High and 300mm deep and fits into a 19” Transmission Rack

6. UNIT CAPACITY – SAM2 SAM2 : SAM2 Main Controller
26 x General Purpose Digital inputs
4 x Generator #1 Digital Inputs
4 x Generator #2 Digital Inputs
4 x Aircon Digital Inputs
6 x Temp Analog Inputs
1 x Analog Input 0-60vdc
1 x Analog Input 0-20mA
3 x Relay outputs – Generator Ctrl
4 x Aircon Drive Outputs
24 x Pix Outputs (RBS)
1 x DC Fan Output, Speed Ctrl
1 x RS485 Port – communication to E1 Controller
Expansion Modules Available:
1 x GSM Modem
1 x Generator Controller (2 x Gen Sets)
2 x Fuel Management (RS485)
1 x Battery Management (RS485)
1 x Utility Management (RS485)
1 x HEM (Hybrid Extension Module)
DC Ventilation Fan

7. UNIT CAPACITY – ITMS Remote Management Modules Available:
IP Communication Controller:
1 x RS232 Port – Unit Configuration Port
2 x TCP/IP Ports
1 x RS485 Port - Communication to SAM2 and Access Control Unit
2 x RS232 Port – Virtual Port
1 x Relay – Lock Failsafe Override
Expansion Modules Available:
SP8 - 8 x RS232 port
SP6 – 6 x RS232 port & 2 x RS485 Port
LAN Card - 4 x TCP/IP Ports
ITMS Controller
SP6 - PCB
DC Ventilation Fan
SP8 - PCB

8. SYSTEM COMPONENTS Wiring Kit Main Control Unit Aircon Control Switch
Wiring Kit
Main
Control Unit
Aircon Control Switch
Smoke
Room Temp & Humidity
AC Mains Phase Frequency Monitor
Door Switch
Movement
Battery Current Probe
Hybrid Extension Module

9. DVR COMPONENTS Video Surveillance 4 Channel DVR Indoor IR Dome Camera
4 Channel DVR
Indoor IR Dome Camera
Video Surveillance
TCP-IP Remotely managed DVR
Four channel CCTV DVR
Eight channel CCTV DVR
CCTV Indoor dome type cameras
CCTV Outdoor bullet type cameras
Indoor TCP-IP Web Cam
4 Channel DVR

10.
Installation
ITMS Components

11. ITMS2 – RACK MOUNT UNIT
Alarm Input Module
ITMS2 Unit

12. DOOR SWITCH
Door Switch

13. MOVEMENT SENSOR
Movement Sensor

14. SMOKE SENSOR
Smoke Sensor

15. ROOM TEMP & HUMDITY SENSOR
Room Temp & Humidity Sensor

16. AC MAINS PHASE MONITOR
AC Main Phase Frequency Monitor

17. HYBRID EXTENSION MODULE
Hybrid Extension Module

18. BATTERY CURRENT CLAMP 200A Probe 500A Probe Wire Lead
200A Probe
500A Probe
Wire Lead
Probe Termination
Blue
GND
Not Connected
Orange
Positive (+)
White/Orange
Negative (-)
White/Blue
Battery Current Clamp 500A
Battery Current Clamp 200A

19. Aircon Control Switch – Clipon Type
Aircon Control Switch
To Second Aircon

20. Aircon Control Switch – Pearl Type
Aircon Control Switch

21. Rectifier – Alarm wiring

22. AC Mains & Generator on load Alarm

23. Surge Protection Alarm

24. Over/Under AC Voltage (Eskom) Alarm
Blue

25. Over/Under AC Voltage (Eskom) Alarm

26. Over/Under AC Voltage (Eskom) Alarm

27. ITMS RS485 COMMS WIRING

28.
SOFTWARE
ITMS

29. SAM2 ECT SAM2 ECT: Current Version ECT – V2.17
ECT Version is viewed on the top left corner as indicated with the yellow circle
EG: “AIU 2 ECT V2.17”
Current Version Firmware – V2.17
Firmware Version is viewed on the top left corner as indicated with the Red circle
EG: “AIU Version: SAM205 V2.17”
Front Panel View:
Room and Aircon Vent temps and run times
Alarm Input Status
Output Status
# The “Front Panel” is a real-time information panel display

30. ITMS ECT (IP Controller)
IP Controller (V Lan Port) ECT:
Current Version ECT – V2.12
ECT Version is viewed on the top left corner as indicated with the yellow circle
EG: “ITMS-C Ver 2.1.2”
Current Version Firmware – V
Firmware Version is viewed on the button left corner as indicated with the Red circle
EG: “S/W: ”

31. THANK YOU