1. Module 4: Learning about Other Devices These Labs can be performed using the following topology or using the ones in the lab books:- 4.1.4 Creating a Network Map using CDP 4.1.6 Using CDP Commands 4.2.2 Establishing and Verifying a Telnet Connection 4.2.3 Suspending and Disconnecting Telnet Sessions 4.2.4 Advanced Telnet Operations 4.2.5a Connectivity Tests – Ping 4.2.5b Connectivity Tests – Traceroute 4.2.6 Troubleshooting IP Address Issues

2. Lab Topology

3. Instructions Use RIP as the routing protocol Use Loopback interfaces to simulate networks Router(config)# int Lo0 Router(config-if)# ip address ….. Use ip unnumbered for the serial interfaces Router(config)#int s0 Router(config-if)# ip unnumbered lo0

4. Module 5: Managing Cisco IOS Software Students can perform these labs:- 5.1.3 Using the Boot System Command 5.1.5 Troubleshooting Config Register Boot Problems 5.2.6a Password Recovery Procedures

5. Module 5: Managing Cisco IOS Software These Labs will be demonstrated 5.2.3 Managing Configuration Files with TFTP 5.2.5 Managing IOS Images with TFTP This lab will be skipped 5.2.6b Managing IOS Images with ROMmon and Xmodem