1. Exploring a CPLD/FPGA-based Triggering System for LCLS Matthew T. Brown Office of Science, Science Undergraduate Laboratory Internship Program Advisor: Ron Akre

2. CPLD/FPGA Basics Gates Macrocells LUTs JTAG Programmer Xilinx ISE

3. Xilinx Cool Runner XPLA XCR3064XL

4. Xilinx Spartan 3 XC3S200PQ208-5

5. The Task at Hand 360Hz fiducial signal Set delays Triggering requirements – Delay – Pulse length – Jitter

6. How It’s Done 24-bit counter Comparators Flip flops Design entry – Schematic – Text (VHDL code written for 8 channels)

7. Simple Timing Diagram

8. Schematic Example

9. CPLD Results Not good enough!

10. FPGA Results

11. FPGA Results Strike Back Jitter measured to be below 2 picoseconds

12. Return of the FPGA Results Onboard Arcturus Coldfire Processor Four DCMs on the chip allow for sub-clock cycle phase adjusting for the triggers

13. Conclusion and Possible Future Work CPLD = No FPGA = Yes Need to: – Build a board with all 8 channels on it – Complete the computer-FPGA interface

14. Acknowledgements Thanks to Ron Akre, Jeff Olsen, Bo Hong, and Anatoly Krasnykh for help on this project. Thanks to Steve Rock, Susan Schultz, and Farah Rahbar for managing us kids and the SULI program at SLAC. Questions? Sources: – http://supercomputing.fnal.gov/slac_logo.jpg http://supercomputing.fnal.gov/slac_logo.jpg – http://images.amazon.com/images/P/6305428387.01.LZZZZZZZ.jpg http://images.amazon.com/images/P/6305428387.01.LZZZZZZZ.jpg – http://therawfeed.com/pix/this_is_sparta.jpg http://therawfeed.com/pix/this_is_sparta.jpg