1. PROGRAMMING FACILITIES

2. PURPOSEPURPOSE The purpose of this presentation is to explain the main principles of programming DS series systems.

3. BASIC PROGRAMMING Two methods: Dialling codes from system supervisor’s telephone Using IDEA program through PC

4. STRUCTURE OF PROGRAMS Programs for whole system like PBX groups, call pick-up groups, call time-outs, hot- line definitions, restricted/permitted prefixes in external calls Programs based on single extensions like Call authorities, call time-outs, hot-line definitions Programs based on single lines like Status & signalling, polarity reversal detection, metering pulse price, ACD/DISA line

5. STRUCTURE OF PROGRAMS Programs for modules like EVM programs, PRI/BRI/E&M line programs, VoIP and LAN Adaptor Card programs Flexible numbering Changing access codes of extensions & lines, changing access codes of facility codes LCR Maintenance programs like EEPROM programming

6. REMOTE PROGRAMMING IN DS SERIES

7. EXTERNAL MODEM Modem is connected to CPUKON card of system by a special cable Telephone line from DS200 extension IDEA in modem connection mode  Required AT commands must be entered on modem  Modem mode must be activated on the system 800090 1

8. EXTERNAL MODEM AT command set for ZYXEL U-90E EXTERNAL MODEM AT&F ; factory-default settings ATS0=1 ; auto-answer after 1 ring ATE0 ; local echo off ATQ1 ; no result code AT&D0 ; ignore DTR signal ATS20=9 ; baud-rate 9600 AT&WZ ; save to default profile

9. EXTERNAL MODEM AT command set for SPEEDCOM 56K EXTERNAL MODEM AT&F0 ; factory-default settings ATS0=1 ; auto-answer after 1 ring ATE0 ; local echo off ATQ1 ; no result code AT&D0 ; ignore DTR signal ATS37=9 ; baud-rate 9600 ATS2=255 disable escape character AT&W0 save to profile number 0 AT&Y0 start with profile 0

10. EXTERNAL MODEM Cable must be specifically prepared as follows: DS200 sideModem side 22 33 57 No connect4,20,25 short circuit

11. EXTERNAL MODEM For connecting to the system, IDEA is run in “Modem Connection” mode:

12. INTERNAL MODEM IDEA in modem connection mode PC with modem, in connection with the system through serial port Telephone line from DS200 extension  COMBRIDGE program required to connect two serial ports of PC  Modem mode must be activated on the system

13. THANK YOU VERY MUCH... int.support@karel.com.tr