Presentation is loading. Please wait.

Presentation is loading. Please wait.

Mega Meet 2014 Calibrating for Performance and Competition.

Published byJoanna O’Connor’ Modified over 9 years ago

Similar presentations

Presentation on theme: "Mega Meet 2014 Calibrating for Performance and Competition."— Presentation transcript:

1 Mega Meet 2014 Calibrating for Performance and Competition

2 Scott Clark Calibration Engineer (Tuner) Custom engine mgt. 10 years MS experience 20+ systems

3 Successful Racing: Time Talent Resources

4 TOOLS & SKILLS Multimeter – Continuity – Voltage – Resistance – RPM, DC Oscilloscope – Crank/Cam Position signals – Actuators (Injectors, Ignition)

5 Project Roles Electronics and Tuning Chassis Engine/Mechanical Project Management / Crew Chief Driver (if absolutely necessary) You might be all of these but the responsibilities are the same!

6 Testing Bench – JimStim! Dynamometer – Ignition – full RPM and load range – Fuel system – leaks, weird behavior, heat soak, etc. Limited testing – Datalogs – prior runs or ECUs

7 Examples EMC 2012 – 385ci Early Hemi YOUTUBE LINK HEMI EMC 2013 – 428ci Pontiac YOUTUBE LINK PONTIAC

8 Examples 2 LSR Charger Daytona YOUTUBE DAYTONA

9 Charger Bonneville Data

Download ppt "Mega Meet 2014 Calibrating for Performance and Competition."

Similar presentations

OBJECTIVES After studying Chapter 2, the reader will be able to:

OBJECTIVES After studying Chapter 2, the reader will be able to:
Engine Control Units A look at technology in the Automotive Industry.

Engine Control Units A look at technology in the Automotive Industry.
An Introduction to EV Wiring By Charlton Jones Gateway EV Washington, MO.

An Introduction to EV Wiring By Charlton Jones Gateway EV Washington, MO.
Diagnostic procedure Training for the future. So, where do we start? Diagnostic Procedure.

Diagnostic procedure Training for the future. So, where do we start? Diagnostic Procedure.
The Smart Battery Assembly Process

The Smart Battery Assembly Process
ECG ELECTRON COMBUSTION GRAPH FOLLOW THE BOUNCING ELECTRON

ECG ELECTRON COMBUSTION GRAPH FOLLOW THE BOUNCING ELECTRON
Engine Electronic Controlled. Ignition systems THE CONSTANT ENERGY IGNITION SYSTEM DIGITAL (PROGRAMMED) IGNITION SYSTEM DISTRIBUTORLESS IGNITION SYSTEM.

Engine Electronic Controlled. Ignition systems THE CONSTANT ENERGY IGNITION SYSTEM DIGITAL (PROGRAMMED) IGNITION SYSTEM DISTRIBUTORLESS IGNITION SYSTEM.
Case Study – Application of Sensors in measuring torque and thrust produced by propellers in small unmanned quad-rotor helicopter.

Case Study – Application of Sensors in measuring torque and thrust produced by propellers in small unmanned quad-rotor helicopter.
Lecture 251 DC Measurements. Lecture 252 DC Measurements DC Measurements include current, voltage, resistance, and power. Section 2.8 should be titled.

Lecture 251 DC Measurements. Lecture 252 DC Measurements DC Measurements include current, voltage, resistance, and power. Section 2.8 should be titled.
Engine Team Status Update February 17, 2009 Jimmy HreskoMike Lin Scott KunzSamihan Yedkar Arianna GoldenMike Velez Costas Akrivoulis.

Engine Team Status Update February 17, 2009 Jimmy HreskoMike Lin Scott KunzSamihan Yedkar Arianna GoldenMike Velez Costas Akrivoulis.
Fuel Evaporation in Ports of SI Engines P M V Subbarao Professor Mechanical Engineering Department Measure of Useful Fuel …..

Fuel Evaporation in Ports of SI Engines P M V Subbarao Professor Mechanical Engineering Department Measure of Useful Fuel …..
5 Gas Analysis Another Rainharbor Production 1997.

5 Gas Analysis Another Rainharbor Production 1997.
Components, Quantities, and Units

Components, Quantities, and Units
What is a scope? Essential tool for automotive diagnostic and fault finding. Ideal for viewing and testing most automotive sensors and circuits. Captures.

What is a scope? Essential tool for automotive diagnostic and fault finding. Ideal for viewing and testing most automotive sensors and circuits. Captures.
1 Advanced D-TAC Testing. 2 D-TAC testing – Part 2 This presentation is meant to be viewed after the introductory presentation ‘D-TAC testing – Batteries.

1 Advanced D-TAC Testing. 2 D-TAC testing – Part 2 This presentation is meant to be viewed after the introductory presentation ‘D-TAC testing – Batteries.
2013 NATEF Task Area A-8 Engine Performance 7-2013 A. General Engine Diagnosis & Testing B. Computerized Engine Controls C. Ignition System Diagnosis &

2013 NATEF Task Area A-8 Engine Performance A. General Engine Diagnosis & Testing B. Computerized Engine Controls C. Ignition System Diagnosis &
Measuring the Current and Voltage of a 820 Ω Resistor Setting for Multimeter = 200 mA DC Measure Voltage in 2 V increments up to 20 V.

Measuring the Current and Voltage of a 820 Ω Resistor Setting for Multimeter = 200 mA DC Measure Voltage in 2 V increments up to 20 V.
INGAS 6 months Meeting, Prague, 25-26 May, 2009 INGAS INtegrated GAS Powertrain 1 CVUT-JBRC Scope Experimental Facilities – General Features – InGAS Customizing.

INGAS 6 months Meeting, Prague, May, 2009 INGAS INtegrated GAS Powertrain 1 CVUT-JBRC Scope Experimental Facilities – General Features – InGAS Customizing.
Ignition Systems Purpose: to produce a high voltage surges, delivered at the correct time and the correct spark plug for different operating conditions.

Ignition Systems Purpose: to produce a high voltage surges, delivered at the correct time and the correct spark plug for different operating conditions.
Automotive Engine Performance, 3/e By James D. Halderman Copyright © 2010, 2007, 2003 Pearson Education, Inc., Upper Saddle River, NJ 07458 All rights.

Automotive Engine Performance, 3/e By James D. Halderman Copyright © 2010, 2007, 2003 Pearson Education, Inc., Upper Saddle River, NJ All rights.

Similar presentations

Ads by Google