1. Chapter 5 Design and Analysis of a Laminate The Drive Shaft Problem Dr. Autar Kaw Department of Mechanical Engineering University of South Florida, Tampa, FL 33620 Courtesy of the Textbook Mechanics of Composite Materials by Kaw

2. Figure 5.4 goes here FIGURE 5.4 Fiberglass facings with a Nomex7 honeycomb core. (Picture Courtesy of M.C. Gill Corporation, http://www.mcgillcorp.com)

3. FIGURE 5.5 Moisture absorption as a function of time and its effect on flexural modulus of a glass/polyester composite rod. (Reprinted from Quinn, J. A., in Design with Advanced Composite Materials, Phillips, L.N., Ed., 1990, Figure 3.10 (p.91) and Figure 3.11 (p.92), Springer-Verlag, Heidelberg.)

4. FIGURE 5.6 Normal and shear stresses at the interface of bottom surface of top ply in a four-ply laminate. (Reprinted from Pagano, N.J. and Soni, S.R., in Interlaminar Response of Composite Materials, Pagano, N.J., Ed., 1989, p.9, Elsevier Science, New York, with kind permission from authors.)

5. FIGURE 5.7 Comparison of residual strength as a function of number of cycles for two laminates. (Reprinted from Pagano, J.J. and Soni, S.R., in Interlaminar Response of Composite Materials, Pagano, N.J., Ed., 1989, p.12, Elsevier Science, New York, with kind permission from authors.