1. Gadget Project By: Steven Richardson and Damien Wellman

2. Construction  Started out build the support frame.  Then attached frame to the RCX.  Constructed reinforcements to connect to other support frame.  Duplicated frame for other side of RCX.  Added tubes to form and oval shape around the top of the gadget.  Lights were then added to finish off initial construction.

3. Testing out the program  Tested out the lights with the RoboLab program.  So far everything is working well.

4. Testing out the program part II  IR sensor communicates with gadget just fine.  Both lights are properly working.  A and C are connected.

5. Step 3 Commenced just fine!

6. On to Step 4  Light Sensor has been tested out for motion.  If light is block out then the touch sensor activates.  If touch sensor activates in 50 seconds it turns on green light if later then red light turns on.