1. Ambient Monitoring Update NACAA Fall Meeting Chet Wayland, AQAD Division Director Office of Air Quality Planning and Standards 1 October 3-5, 2011 Cleveland, OH

2. Ambient Monitoring Revisions Strategic Overview 2 EPA has updated ambient monitoring requirements to support long overdue revisions to the NAAQS These revisions directly support key public health related objectives: –Characterizing peak concentrations where people are exposed –Providing support for air quality index notifications –Providing information to inform control measures that lead to compliance EPA has embraced a flexible and efficient monitoring approach that emphasizes multi-pollutant monitoring, extended deployment timelines, adequate equipment funding, and the discontinuation of low-value monitors.

3. New Monitoring Requirements 3

4. 4 In 2010, EPA strengthened the health-based National Ambient Air Quality Standard (NAAQS) for nitrogen dioxide (NO 2 ) by adding a new 1-hour standard. The new NO 2 standard protects public health by limiting short-term exposures to NO 2 concentrations that could worsen the control of asthma and that have been linked to hospital admissions and emergency room visits for respiratory illnesses, particularly in at-risk populations such as children, the elderly, and asthmatics. The revised NAAQS defines the maximum allowable NO 2 concentration anywhere in an area. Therefore, the degree of public health protection envisioned under this revised standard will only be achieved if attainment/non-attainment classifications are based on monitoring of peak 1-hour NO 2 concentrations. In considering the locations where such peak NO 2 concentrations are likely to occur, we note that NO 2 concentrations in many urban areas are likely to be highest around major roads. Specifically, monitoring studies and modeling efforts indicate that NO 2 concentrations in heavy traffic or near major roadways can be twice as high as concentrations measured away from such roads, increasing exposures to ambient NO 2 for people who live, work, or attend school near major roads and for people who spend time commuting on major roads. Given the elevated NO 2 concentrations near major roads and the potential for peak human exposures to occur on or near such roads, and given that the public health protection envisioned under the revised NO 2 NAAQS depends on States monitoring peak 1-hour NO 2 concentrations, the final NO 2 NAAQS requires monitors near major roadways in large urban areas. Only with these near-road monitors in place will the revised NO 2 NAAQS lead to the degree of public health protection envisioned in the final rule. Near-Road Monitoring – Protecting Public Health

5. NO2 - Near-road Monitoring Plan 5 EPA and NACAA have developed the Build and Hold plan to initially deploy near-road NO2 monitors in areas >1M population (subset of original requirements). –Monitors to be deployed over two years (2013 and 2014) –Section 103 funding to cover establishment costs such as planning, construction, permits, shelters, monitors, etc. $5M in FY11 funds to be distributed this fall for phase 1 $5M in FY12 funds requested for phase 2 –Resulting ambient data will inform further network decisions –Detailed siting Technical Assistance Document and Build and Hold Q&A’s have been developed –Consistent with CASAC advice to deploy in stages Near-road network critical aspect of NAAQS revision since level was chosen to represent peak exposure locations

6. CO - Near-road Monitoring Plan 6 EPA recently finalized revisions to CO monitoring requirements as part of NAAQS review. Near-road CO monitors (total = 52) required at NO2 sites as follows: –CBSA’s of >2.5M population by January 1, 2015 –CBSA’s of >1M population by January 1, 2017 EPA expects existing CO monitors will be relocated to near-road sites, noting: –There are no requirements for other CO monitors except for ~80 NCore stations that are already operating (total of 313 CO monitors in operation during 2011) –Hundreds of low reading CO monitors are being operated nationally (slide 12) –EPA regional office experience has demonstrated that CO monitors can be discontinued even if referenced in maintenance plans and SIP’s

7. Summary: EPA’s Adjustments to NO2/CO Requirements to Address Burden Concerns 7 Downsized NO2 network with Build and Hold plan; staggered deployment as recommended by NACAA and CASAC; paid for by §103 funds Future network build-out based on resulting data Modest CO network that leverages multi-pollutant concept and acknowledges opportunities for legacy monitor divestment and relocation; extended timelines to 2017 EPA support for review of existing NO2 sites to satisfy area-wide and 40 “Sensitive and Vulnerable population” monitor requirements (next slide)

8. 8 Meeting the NO2 Sensitive & Vulnerable Population Monitoring Requirement Overview: 40 “additional” monitors are required in areas with sensitive and vulnerable populations Using a prototype EPA tool to identify “Areas of Concern”, EPA has identified 128 NO2 monitors being operated in such areas We recommend that RA’s work with states to identify which monitors will be used to meet requirements Document in Annual Monitoring Network Plans due July 1, 2012

9. Legacy Monitoring Requirements Question: What opportunities for divestment exist across the country? Using SO2, NO2, and CO as examples to compare actual network size to current federal requirements 9

10. 10 SO2 Monitors – Active in 2011 SO2 by the Numbers: Active = 424 Required by CFR = 129 Excess in CBSA areas = 112 Additional excess = 183 A few of these monitors are for the NCore network Objectives for remaining monitors should be reviewed

11. 11 NO2 Monitors – Active in 2011 NO2 by the Numbers: Active = 364 Required by CFR = 52 Excess in CBSA areas = 126 Additional excess = 186 Objectives for remaining should be reviewed Some monitors can be used to meet “RA 40”

12. 12 CO Monitors – Active in 2011 CO by the Numbers: Active = 313 Required by CFR NCore = 81 near-road = 52 (2015/2017) Excess = 180 Objectives for excess monitors should be reviewed

13. Recommendations 13 States are running far more SO2, NO2, and CO monitors than required by current federal requirements These networks, along with PM10, should be closely reviewed for redundancy and value on a monitor-by- monitor basis Work with your EPA Regional Office to develop plans for monitor divestment and/or relocation Resulting burden reduction in monitor operations, quality assurance, and data validation and reporting can partially offset new requirements such as near-road and lead monitoring

14. Additional Monitoring Burden Reductions 14 Status of ozone monitoring final rule under review –No new monitors –Ozone monitoring seasons may be expanded as appropriate to support NAAQS if rule goes forward Proposed secondary NOx/SOx monitoring framework will not require new state/local operated monitors –Plan is to leverage existing CASTNET framework in 3-5 sensitive eco-regions EPA not currently envisioning network expansion for PM2.5 or to support characterization of urban visibility Final lead monitoring plan eliminated separate non- source network and reduced airport monitoring from ~70 locations with > 0.5 TPY emissions to only 15 airports with higher NAAQS risk (next slide)

15. Lead Monitoring Requirements 15 Section 105 funding for ½ TPY lead sources distributed last spring –Additional sites to be operational by December 27, 2011 –Network size smaller than anticipated due to waiver provisions and reduced emissions in updated NEI Section 103 funding for 15 airport sites was distributed to affected regions in August –All sites are on schedule to commence their 1-year of monitoring by December 27, 2011 –Monitors readings > 50% of NAAQS will become permanent

16. Key Monitoring Issues For Your Staff Network Investments 16 Build and Hold (NO2) states should be reviewing near-road Technical Assistance Document and starting dialogue with Regions regarding funding and siting –http://www.epa.gov/ttnamti1/nearroad.htmlhttp://www.epa.gov/ttnamti1/nearroad.html States should be reviewing existing NO2 and SO2 monitors to assess compliance with NO2 area-wide requirement (CBSA’s > 1M), EJ requirement, and PWEI minimums (SO2) –EPA supports use of existing monitors to meet requirements where appropriate Fully implement NCore multi-pollutant sites and focus on data quality and reporting issues for newer measurements such as high-sensitivity gases and PM 10-2.5 mass.

17. Key Monitoring Issues For Your Staff Network Efficiencies 17 States should be implementing 2010 network assessment recommendations and discontinue legacy CO, SO2, NO2, and PM10 monitors not needed for federal requirements, overarching state/local needs, or national heath studies –Commence discussions with regions to prioritize and discontinue these monitors utilizing annual network monitoring plan process –Determine necessary steps for revising maintenance plans that reference monitors Review continuous PM2.5 FEM operating procedures and conduct data quality comparisons with FRM’s to evaluate method performance and identify areas for improvement –Supports potential divestment of some manual FRM’s Consider replacing archaic state data systems with newer data management products that support automated control of monitor calibrations, monitor diagnostics, and data screening, flagging, and reporting actions –http://www.epa.gov/networkg/http://www.epa.gov/networkg/

18. Issue –Continuous FEMs do not achieve the same performance in the field, and generate data that are biased high (compared to FRM) in areas with high humidity, high nitrates, and urban aerosol. –Positive bias of continuous FEMs is an issue for areas near the NAAQS as possible risk of non-attainment What is EPA doing to enable State/local Monitoring agencies to be successful with PM2.5 continuous FEMs? –Technical note on PM2.5 FEM data reporting provides for use of FEM for up to 24 months as an SPM without comparison to NAAQS. –Developed consensus SOP’s for the most widely used continuous PM methods –Working closely with multiple stakeholders such as the NACAA monitoring steering committee, ORD, and the instrument companies. –Implementing recommendations from NACAA monitoring steering committee: Tool for monitoring agencies to quickly assess their continuous FEM data quality Providing flexibility for monitoring agencies to determine if their continuous FEM provides data of sufficient comparability to collocated FRM for comparison to the NAAQS - planned for inclusion in PM NAAQS/monitoring proposal. Troubleshooting/Best practices document for each of the major deployed continuous FEMs to assist monitoring agencies with improving data quality 18 PM2.5 FEM Data Quality Issues

19. Questions? U.S. Environmental Protection Agency19