Download presentation
Presentation is loading. Please wait.
Published byKelly George Modified over 9 years ago
1
Hoisting, Rigging and Crane Safety Training 1
2
GoalGoal Subcontractors using cranes (mobile, tower, etc.) and crane substitutes at SLAC 2
3
SLAC Construction Sub-contractors Designate Qualified and Competent Persons: –Assembly/Disassembly (A/D) Director; qualified –Crane Operator; licensed/certificated –Signal Person; qualified –Rigger; qualified –Oiler; designated by employer –Helper; works under direction of employer designated person Training Recordkeeping: SSSP Follow DOE 1090 and SLAC Chapter 41 3
4
SLAC Construction Sub-contractors Operators* –NCCCO – National Commission for the Certification of Crane Operators –IUOE - International Union of Operating Engineers, Local 12, Pasadena, CA * Not required if crane capacity is equal to or less than 2,000 lbs. 4
5
Licenses: NCCCO 5
6
Licenses: IUOE 6
7
Qualified & Competent Assembly/Disassembly Director; qualified; –Designated by the employer Signal Person; qualified –Third-party trained or, –Employer trained Rigger; qualified –Third-party trained or, –Employer trained 7
8
Crane Types 8 T RUCK MOUNT M OBILE O N - ROAD & O FF - ROAD M OBILE O N - ROAD & O FF - ROAD
9
Crane Types (substitutes) Excavator Loader/Backhoe Rough Terrain Forklift 9 Note: currently do not require a crane operators license Requires a load chart
10
Crane Inspection and Safety Crane Operator Certifications: NCCCO or IUOE Crane inspection and maintenance records available Load rating chart; capacity chart Outriggers/leveling (outriggers not damaged) Crane leveled within 1 percent Moving parts are guarded/ no guards removed Wire rope on sheaves, drums, rigging, hardware, and attachments (Six randomly distributed broken wires in one lay or three broken wires in one strand in one lay) No physical damage to boom/jib (structural integrity OK) Tires inflated, no cuts/tears 10
11
Crane Inspection and Safety No fluid leaks (air & hydraulic) Fuel & lubricating oil reservoirs properly filled Operator cab equipped with fully charged fire extinguisher; 10BC (ASME B30.5) Operating mechanisms functional (lights, sheaves, drums, outriggers, turntable connections – all OK) Limit switch connected and functioning Inspect and test all brakes and clutches Check load moment indicators – operating Crane cab (wind shield OK, gauges & warning lights functioning) 11
12
Crane Inspection 12 Required: –Annual Inspection –Quadrennial Inspection *Note: A quadrennial can serve as an annual
13
Rigging Equipment Sling Shackle Hook Spreader Attachments 13 Must meet ASME B30.20 or BTH Standard
14
Rigging on Lifts 14 No Free Rigging on forks, Must have manufacturers label or Engineering along with corresponding load chart on the lift.
15
Rigging Inspections Each day before being used, the sling and all fastenings and attachments shall be inspected for damage or defects by a qualified person. Additional inspections shall be performed during sling use, where service conditions warrant. Damaged or defective slings shall be immediately removed from service. 15
16
OperationsOperations 16 Accepted lift plan in the red folder Load rigged according to manufacturers recommendations
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.