1. AERB Safety Research Institute 1 TIC Benchmark Analysis Subrata Bera Safety Research Institute (SRI) Atomic Energy Regulatory Board (AERB) Kalpakkam – 603102, India Joint IAEA-ICTP Workshop on Nuclear Reaction Data for Advanced Reactor Technologies

2. AERB Safety Research Institute 2 AIM: To understand physics properties of VVER type Lattices and validate the code EXCEL (Lattice code). Nu Power, Vol.16,No. 1-2 (2002).

3. AERB Safety Research Institute 3 TIC: Temporary International Collective Established by 7 CMEA member states in 1972 1.Bulgaria 2. Czechoslovakia 3. Germany 4.Hungary 5. Poland 6. Romania 7. Union of Soviet Socialist republics (USSR) AIM of TIC: --- to perform Experimental Reactor physics investigations into VVER- type lattices. --- to collect neutron physics operational data of VVER-type power reactors in start-up and in steady state condition for checking codes. Ref: “Theoretical investigations of the physical properties of WWER-type uranium-Water Lattices”, Akademiai kiado, Budapest(1994), final volume.

4. AERB Safety Research Institute 4 TIC (contd..) --- performed a wide range of experimental investigations including measurements of criticality parameters, spectral ratios, reaction rate distributions, kinetic parameters of VVER-type fuel lattices as a function of uranium enrichment, lattice pitch, boron concentration in the moderator, etc. --- the Experimental Results presented in vol-1 of the final report of TIC are based on measurements carried out on the critical assembly ZR-6. Ref: “Theoretical investigations of the physical properties of WWER-type uranium-Water Lattices”, Akademiai kiado, Budapest(1994), final volume.

5. AERB Safety Research Institute 5 ZR-6 critical Facility --- operated by the Central Research Institute for Physics (CRIP) of Hungarian Academy of Sciences, Budapest. --- zero power clean critical facility --- around 150 benchmark problems were investigated and reported in Final report of TIC vol.-1. General view of the critical facility Tank(SS) Dia: 1.8 m

6. AERB Safety Research Institute 6 --- lattice type: Hexagonal (pitch:1.27cm, 1.1 cm) ---fuel rod are identical with VVER-type power reactor except central hole (missing here) and their length (125 cm here) while 250 cm for VVER-400 and 350 cm for VVER-1000. --- fuel: Enriched Uranium (UO2)(Enrichment, atom%: 1.6, 3.6, 4.4) --- moderator: Borated light water (C B (g/l): 0, 0.64, 1.41, 1.85, 4.0, 7.2) --- moderator nominal temp.: 22 0 C --- Criticality achieved by varying moderator height. --- core configuration: Pitch(mm)/enr(at%)/cb(g/l) ZR-6 critical Facility (Contd..)

7. AERB Safety Research Institute 7 Type of lattices were investigated: Regular one region cores Pitch:12.7mm. 11 mm(for Enr=3.6%) Enrichment: 1.6%, 3.6%, 4.4% Boron conc.(g/l): 0, 0.64, 1.41, 1.85, 4.0, 7.2 No.of investigated problems: 46 One region cores

8. AERB Safety Research Institute 8 Method of solution: Infinite regular lattice will give identical neutron multiplication factor as one pincell with reflective boundary condition. For finite lattice leakage factor (DB 2, depending on buckling) have to be considered. For same core configuration (Pitch/Enr/B Conc.) many experiments were carried out with different no. of fuel pins of regular lattice at different critical moderator height. For same core configuration of regular lattice only one problem is analyzed to generate few group CXS ( 5 groups: 19.6MeV to 9.118KeV, 9.118KeV to 4eV, 4eV to 0.625eV, 0.625eV to 0.14eV and 0.14eV to 0.00001eV ) parameters with help of EXCEL. Five group parameters: Regular one region lattice

9. AERB Safety Research Institute 9 EXCEL: A hexagonal lattice Burn-up code Solves 1D transport equation for pincell and gives 172 groups fluxes using 172 groups basic CXS library by collision probability method. CXS of a super cell:group of pincell, are homogenized and collapsed into 5 groups CXS by considering flux and volume weighting. 5 group CXSs are used to solve 2D Diffusion equation and Assembly wise 5 groups CXS parameters are generated. Zero dimensional Diffusion equation is solved to get effective neutron multiplication factor with considering proper neutron leakage from the system. Regular one region lattice

10. AERB Safety Research Institute 10 Zero dimension Diffusion equation Normalization of fission neutron Diffusion equation: 5 group diffusion equation:

11. AERB Safety Research Institute 11 Matrix form of 5 group Diffusion equation: Calculation of:

12. AERB Safety Research Institute 12 Program, Input & Output

13. AERB Safety Research Institute 13 Analysis of regular lattices Core configuration 1.27/3.6/0.0. Total 21 cases analysed Req is increasing with no of fuel pin. Hcr is decreasing with no of fuel pin. Buckling is almost constant Average K-eff is 0.9972 Regular one region lattice Variation of R eq, H cr and Buckling with number of fuel pins

14. AERB Safety Research Institute 14 Config. coreID K-Inf K-Eff --------------------------------------------- 1.27/3.6/4.0 2727 1.29163 0.99994 3333 1.29165 0.99998 3434 1.29166 1.00002 182B 1.29166 1.00003 2828 1.29166 1.00005 3232 1.29167 1.00007 3636 1.29168 1.00009 3131 1.29168 1.00012 3030 1.29169 1.00015 2626 1.29170 1.00017 142B 1.29171 1.00022 122A 1.29173 1.00027 2929 1.29174 1.00030 --------------------------------------------- 1.27/3.6/7.2 3838 1.21648 1.00085 3737 1.21652 1.00099 --------------------------------------------- 1.27/4.4/0.0 1102 1.44184 1.00403 --------------------------------------------- 1.27/4.4/0.64 1112 1.42422 0.99213 --------------------------------------------- 1.1/3.6/0.0 4141 1.29371 0.97970 3939 1.29363 0.97949 4040 1.29361 0.97946 --------------------------------------------- 1.1/3.6/1.41 4240 1.27275 0.98719 Analysis of other core configuration

15. AERB Safety Research Institute 15 Borated water effect in criticality Config.CbCoreIDFpinsBucklingK-effEpi/Thm 1.27/3.6/*0 4.0 7.2 174/174 32/32 38/38 769 1302 1801 0.00993 0.0075 0.00558 0.99928 1.00037 1.00776 6.034 6.401 6.687 Lattice will be critical with less number of fuel pins when boron in moderator is less. If boron is in the moderator excess reactivity have to be supplied. K-eff is decreases with boron concentration. For 1 g/l change k-eff will change ~15mk

16. AERB Safety Research Institute 16 Lattice pitch effect on criticality Config.PitchCoreIDFpinsBucklingK-effEpi/Thm */3.6/0.01.27 1.10 174/174 41/41 769 1597 0.00993 0.00663 0.99928 0.98119 6.034 10.890 Changing of lattice pitch effects on moderator thickness around fuel pin. It can be under moderation or over moderation. Both reduces on neutron population as well as on criticality also. To make those lattices critical excess reactivity have to be provided.

17. AERB Safety Research Institute 17 Conclusions 1.The computed keff values for both regular one-region lattices are overall in good agreement with the benchmark values. 2.Smaller lattice pitch there is some disagreement in the computed results compared to benchmark values. This zero dimensional diffusion equation may not be adequate to calculate fast neutron leakage from the core. Higher dimensional diffusion equation may give better result.

18. AERB Safety Research Institute 18

19. AERB Safety Research Institute 19