2. TIRE BALANCING

3. Tire Balancing WEAR YOUR SAFTY GLASSES!!!

4. KNOW YOUR TOOLS TIRE WIDTH CALIPER WEIGHT HAMMER

5. Select Proper Inner Alignment Cone

6. PUT TIRE ON MACHINE

7. Carefully Place Wheel Onto Balancer Quill Shaft

8. Slide Wheel Fully Up Onto Inner Cone

9. Use Hub Nut (spinner) to Tighten Wheel onto the Balancer Quill

10. MEASURE TIRE WIDTH WITH CALIPER

11. Determine “Away” Distance Using Laser Arm

12. Determine “Diameter” From Tire Size Listing On Both Sides of Tire

13. Wheel Balancer DISPLAY SCREEN

14. Insert “W”idth, “D”iameter, & “ A”way Settings into Balancer Display

15. After you are done entering the width on the keypad then put the shield down and the machine will test the tire and give you the results.

16. Select to Correct Amount of Weight From the Sorting Tray

17. After the machine gives you the results put the correct amount of weight on both sides of the tire.

18. Align the Balance Line As Shown, Add the Amount Of Weight Displayed At the 12:00 Position Of the Wheel. The Final Result Should Be ‘Zeros’ in the Left & Right Plane Displays

19. Remove the Finished Wheel From the Balancer, Put Away All Weights & Weight-Tools, Fill-Out Task Sheet With Required Info CLEAN UP AFTER YOURSELVES. TAKE CARE OF YOUR WORK SPACE