3.  Full set of wrenches and sockets  Screw drivers  Tape measure

5.  The first step is to put in the front axle block it up and bolt in the tie rods. Then your able to slide in the torsion bars and bolt on the arms and stops.

6.  Next you can put in the rear end and bolt on the torque tube. Then bolt in the rear motor plate and then also bolt the front of the torque tube on to the rear motor plate.

7.  Now you are able to bolt on the tie rods and also slide in the torsion bars and then bolt the arms and stops on.

8.  All the body parts are held on by dzus buttons.

11.  Thank all of you for coming and experiencing my presentation. Thanks you taking time to come judge me its very much appreciated.