1. Molecular Spectroscopy Visible and Ultraviolet Spectroscopy － UV/VIS Spectroscopy － UV/VIS Spectrometer － Application for Quantitative Analysis

2. Ultraviolet: 190~400nm Violet: 400 - 420 nm Indigo: 420 - 440 nm Blue: 440 - 490 nm Green: 490 - 570 nm Yellow: 570 - 585 nm Orange: 585 - 620 nm Red: 620 - 780 nm

4. Internal Energy of Molecules E total =E trans +E elec +E vib +E rot +E nucl E elec : electronic transitions (UV, X-ray) E vib : vibrational transitions (Infrared) E rot : rotational transitions (Microwave) E nucl : nucleus spin (nuclear magnetic resonance) or (MRI: magnetic resonance imaging)

6. Electronic Spectroscopy Ultraviolet (UV) and visible (VIS) spectroscopy This is the earliest method of molecular spectroscopy. A phenomenon of interaction of molecules with ultraviolet and visible lights. Absorption of photon results in electronic transition of a molecule, and electrons are promoted from ground state to higher electronic states.

7. UV and Visible Spectroscopy In structure determination : UV-VIS spectroscopy is used to detect the presence of chromophores like dienes, aromatics, polyenes, and conjugated ketones, etc.

8. Electronic transitions There are three types of electronic transition which can be considered; Transitions involving , , and n electrons Transitions involving charge-transfer electrons Transitions involving d and f electrons

9. Absorbing species containing , , and n electrons Absorption of ultraviolet and visible radiation in organic molecules is restricted to certain functional groups (chromophores) that contain valence electrons of low excitation energy.

10. UV/VIS Vacuum UV or Far UV (λ<190 nm )

12.  Transitions An electron in a bonding s orbital is excited to the corresponding antibonding orbital. The energy required is large. For example, methane (which has only C-H bonds, and can only undergo  transitions) shows an absorbance maximum at 125 nm. Absorption maxima due to  transitions are not seen in typical UV-VIS spectra (200 - 700 nm)

13. n  Transitions Saturated compounds containing atoms with lone pairs (non-bonding electrons) are capable of n  transitions. These transitions usually need less energy than  transitions. They can be initiated by light whose wavelength is in the range 150 - 250 nm. The number of organic functional groups with n  peaks in the UV region is small.

14. n  and  Transitions Most absorption spectroscopy of organic compounds is based on transitions of n or  electrons to the  excited state. These transitions fall in an experimentally convenient region of the spectrum (200 - 700 nm). These transitions need an unsaturated group in the molecule to provide the  electrons.

15. ChromophoreExcitation max, nm Solvent C=C →*→* 171hexane C=O n→  *  →  * 290 180hexane N=O n→  *  →  * 275 200ethanol C-X X=Br, I n→  * 205 255hexane

17. Terms describing UV absorptions 1. Chromophores: functional groups that give electronic transitions. 2. Bathochromic shift: shift to longer λ, also called red shift. 3. Hysochromic shift: shift to shorter λ, also called blue shift. 4. Hyperchromism: increase in ε of a band. 5. Hypochromism: decrease in ε of a band.

19. Selection Rule Orbital Spin States & Multiplicity Singlet state (S):Most molecules have ground state with all electron spin paired and most excited state also have electron spin all paired, even though they may be one electron each lying in two different orbital. Such states have zero total spin and spin multiplicities of 1, are called singlet (S) states. Total Spin Multiplicities

20. Multiplicity Triplet State For some of the excited states, there are states with a pair of electrons having their spins parallel (in two orbitals), leading to total spin of 1 and multiplicities of 3. Total SpinMultiplicities

21. Selection Rule For triplet state: Under the influence of external field, there are three values (i.e. 3 energy states) of +1, 0, -1 times the angular momentum. Such states are called triplet states (T). According to the selection rule, S→S, T→T, are allowed transitions, but S→T, T→S, are forbidden transitions.

22. Selection Rules of electronic transition Electronic transitions may be classed as intense or weak according to the magnitude of ε max that corresponds to allowed or forbidden transition as governed by the following selection rules of electronic transition: Spin selection rule: there should be no change in spin orientation or no spin inversion during these transitions. Thus, S→S, T→T, are allowed, but S→T, T→S, are forbidden. ( △ S=0 transition allowed)

24.  → 

25. Instrumentation 光源 分光器 樣品 偵測器 記錄器

26. Components of a Spectrophotometer Light Source Deuterium Lamps － a truly continuous spectrum in the ultraviolet region is produced by electrical excitation of deuterium at low pressure. (160nm~375nm) Tungsten Filament Lamps － the most common source of visible and near infrared radiation.

27. Components of a Spectrophotometer Monochromator ( 分光器 / 單光器 ) Used as a filter: the monochromator will select a narrow portion of the spectrum (the bandpass) of a given source Used in analysis: the monochromator will sequentially select for the detector to record the different components (spectrum) of any source or sample emitting light.

28. Monochromator Czerny-Turner design

29. Grating

30. Photomultiplier Detector

31. Principle of Photomultiplier Detector The type is commonly used. The detector consists of a photoemissive cathode coupled with a series of electron- multiplying dynode stages, and usually called a photomultiplier. The primary electrons ejected from the photo- cathode are accelerated by an electric field so as to strike a small area on the first dynode.

32. Principle of Photomultiplier Detector The impinging electrons strike with enough energy to eject two to five secondary electrons, which are accelerated to the second dynode to eject still more electrons. A photomultiplier may have 9 to 16 stages, and overall gain of 10 6 ~10 9 electrons per incident photon.

33. Single and Double Beam Spectrometer Single-Beam: There is only one light beam or optical path from the source through to the detector. Double-Beam: The light from the source, after passing through the monochromator, is split into two separate beams-one for the sample and the other for the reference.

35. Quantitative Analysis Beer’s Law A=  bc  : the molar absorptivity (L mol -1 cm -1 ) b: the path length of the sample c :the concentration of the compound in solution, expressed in mol L -1

36. Transmittance I0I0 I b

38. External Standard and the Calibration Curve

39. Fluorescence Spectroscopy

41. Excitation of Molecules Excitation of molecules can be brought about by absorption of two bands of radiation, one centered about the wavelength 1 (S 0 →S 1 ) and the second around the shorter wavelength 2 (S 0 →S 2 ).

42. Vibrational Relaxation (VR) The molecule can rapidly dissipate excess vibrational energy as heat by collision with solvent molecules. Average lifetime of vibrational relaxation excited molecule is 10 -12 sec or less. Fluorescence always involves a transition from the lowest vibrational level of an excited state to any one of the vibrational level of the ground state.

43. Internal Conversion (IC) A molecule passes to a lower energy electronic state. The molecule can pass from a low vibrational level of S 2 to an equally energetic vibrational level of the first excited singlet S 1. The mechanism of internal conversion process S 2 → S 1 is not well understood. Average lifetime of internal conversion process is 10 -12 sec or less.

44. Fluorescence This process of emitting a photon for deexcitation of S 1 to S 0. Average lifetime of fluorescence is 10 -9 ~10 -7 sec.

45. Intersystem Crossing (ISC) This process of non-radiative transfer from the singlet to the triplet state. Intersystem crossing are most common in molecules that contain heavy atoms, such as iodine or bromine. Interaction between the spin and orbital motions becomes large in the presence of such atoms.

46. Phosphorescence From T 1, the molecule can return to S 0 by emission of photon. A triplet-singlet transition is much less probability than a singlet-singlet conversion. The excited triplet state with respect to emission ranges from 10 -4 to 10sec.

47. Rate of Deactivation Processes Absorption － 10 -14 ~10 -15 sec Vibrational Relaxation and Internal Conversion － 10 -12 sec or less Fluorescence － 10 -9 ~10 -7 sec Phosphorescence － 10 -3 ~10sec

48. Transition Types in Fluorescence Fluorescence process seldom results from absorption of UV radiation of wavelengths lower than 250nm because such radiation is sufficiently energetic to cause deactivation of the excited states by pre-dissociation or dissociation 200nm radiation corresponds to about 140Kcal/mol; most molecules have at least some bonds that cane be ruptured.

49. Quantum Efficiency Comparison for  →  * and n→  * transition The majority radiation of fluorescent compounds is produced by a transition involving either the n→  * or the  →  * excited state. The molar absorptivity of a  →  * transition is ordinarily 100 to 1000 times greater than for an n→  * process.

50. The inherent lifetime associated with a  →  * transition is shorter (10 -7 to 10 -9 sec compared with 10 -5 to 10 -7 sec for an n→  * process) and k f is larger. The rate constant for intersystem crossing k i is smaller for  →  * excited states. Fluorescence is more commonly associated with  →  * states than with n→  * states because the deactivation processes that compete with fluorescence are less likely to occur.

51. Fluorescence and Structure The most intense and most useful fluorescent behavior is found in compounds containing aromatic functional groups with low energy  →  * transition levels. Compounds containing aliphatic and alicyclic carbonyl structures or highly conjugated double bond structure may also exhibit fluorescence.

52. Organic Compounds for Fluorescence Vitamin A has a blue fluorescence with an emission maximum at approximately 500nm in ethanol. highly conjugated compound

55. Fluorescence Instrumentation Source － xenon-arc lamp for higher wavelengths and mercury-arc lamp for shorter wavelengths Lensing system － quartz lenses can be used in the ultraviolet wavelength range (200-380nm), and glass lenses can be used in the visible wavelength range (380nm-700nm)

57. Fluorescence Instrumentation Emission wavelength selector: this system is generally placed at an angle of 90 o with respect to the excitation axis to minimize interferences from transmitted and scattered exciting light. Beam Splitter: A beam splitter is a mirror of partial reflectance. A proportion of light would be reflected from the beam splitter while the rest would be transmitted through it unaffected.