1. Prepared by: Tamer Jaber AN-NAJAH NATIONAL UNIVERSITY FACULTY OF ENGNEERING ELECTRICAL DEPARTMENT Supervised by: Prof. Marwan M.Mahmoud 2008-2009

2. The project aims to measure the I-VThe project aims to measure the I-V Characteristics of a solar cell & module. This will be done using power electronic, PIC circuits and an Interface using C#.This will be done using power electronic, PIC circuits and an Interface using C#.

4. It can be considered as a quality and performance certificate for each PV generatorIt can be considered as a quality and performance certificate for each PV generator Measuring and collecting current and voltage of the solar cell should be large enough to be analyzed to find the electric features of the solar cellMeasuring and collecting current and voltage of the solar cell should be large enough to be analyzed to find the electric features of the solar cell

5. The interface Available models

8. Where (ts )is the time needed to measure the characteristics In the project we used a standard module (Siemens M53)(Vo.c=22v, Is.c=3.4A) Number of capacitors were determined depending on the ratings of the module

9. Switches shown can be manual or automatic (transistors or relays) R L to discharge the capacitors via S3 R shunt to enable us to determine the current from voltage.

12. Determining the sample time interval and start importing from serial port Arrange the data in the table,find the max power,Voc, Isc,Vmpp, Impp and the radiation and T’s Draw the data and auto scale it and fill the square operation Calculate the fill factor and the efficiency

13. *How to measure the Radiation: To measure the radiation we make an equivalent sensor consists of thin film cell with an adapter consists of two terminals and a resistor 50Ω 1 watt We test this cell by comparing its reading in volts to the reading of solar meter and we find that the relation is liner in this equation: G= 227.6V- 69.62

14. *The scaling of Voltage and Current: we used a voltage divider circuit to regulate the voltage and OP-AMP to amplify the current * The Temperature Sensor: we use (LM355) sensor to measure the ambient temperature.

17. Thank You You