1. Vectors n v
What is the projection of the vector (1, 3, 2) onto the plane described by ?
Louisiana Tech University
Ruston, LA 71272

2. Cross Product In Cartesian Coordiantes: Used for: Moments Vorticity
Louisiana Tech University
Ruston, LA 71272

3. Forces Body Forces Pressure Normal Stresses Shear Stresses
Louisiana Tech University
Ruston, LA 71272

4. What is a Fluid?
Solid: Stress is proportional to strain (like a spring).
Fluid: Stress is proportional to strain rate.
Louisiana Tech University
Ruston, LA 71272

5. The Stress Tensor (Fluids)
One dimensional
For fluids:
Three-Dimensional, where u is velocity
Louisiana Tech University
Ruston, LA 71272

6. The Stress Tensor (Solids)
One dimensional
For solids:
Three-Dimensional, where u is displacement
Louisiana Tech University
Ruston, LA 71272

7. Non-Newtonian Fluid (One dimensional) For fluids:
m is a function of strain rate
Louisiana Tech University
Ruston, LA 71272

8. Apparent Viscosity of Blood
Non-Newtonian Region
Rouleau Formation
meff
3.5 g/(cm-s)
1 dyne/cm2
Louisiana Tech University
Ruston, LA 71272

9. The Sturm Liouville Problem
Be able to reduce the Sturm Liouville problem to special cases.
Or equivalently:
Louisiana Tech University
Ruston, LA 71272

10. Orthogonality
From Bessel’s equation, we have w(x) = x, and the derivative is zero at x = 0, so it follows immediately that:
Provided that lm and ln are values of l for which the Bessel function is zero at x = 1.
Louisiana Tech University
Ruston, LA 71272

11. Lagrangian vs. Eulerian
Consider the flow configuration below:
The velocity at the left must be smaller than the velocity in the middle.
What is the relationship?
If the flow is steady, is v(t) at any point in the flow a function of time?
Louisiana Tech University
Ruston, LA 71272

12. Lagrangian vs. Eulerian
Conceptually, how are these two viewpoints different?
Why can’t you just use dv/dt to get acceleration in an Eulerian reference frame?
Give an example of an Eulerian measurement.
Be able to describe both viewpoints mathematically.
Louisiana Tech University
Ruston, LA 71272

13. Exercise Consider the flow configuration below:
Assume that along the red line:
a. What is the velocity at x = -1 and x = 0?
b. Does fluid need to accelerate as it goes to x = 0?
c. How would you calculate the acceleration at x = -0.5?
d. How would you calculate acceleration for the more general case v = f(x)?
e. Can you say that acceleration is a = dv/dt?
Louisiana Tech University
Ruston, LA 71272

14. Streamlines, Streaklines, Pathlines and Flowlines
Be able to draw each of these for a given (simple) flow.
Understand why they are different when flow is unsteady.
Be able to provide an example in which they are different.
If shown a picture of lines, be able to say which type of line it is.
Be able to write down a differential equation for each type of line.
So:
Louisiana Tech University
Ruston, LA 71272

15. Flow Lines
Louisiana Tech University
Ruston, LA 71272

16. Flow Lines
Louisiana Tech University
Ruston, LA 71272

17. Conservation Laws: Mathematically
All three conservation laws can be expressed mathematically as follows:
Production of the entity (e.g. mass, momentum, energy)
Increase of “entity per unit volume”
Flux of “entity per unit volume” out of the surface of the volume
(n is the outward normal)
is some entity. It could be mass, energy or momentum.
is some property per unit volume. It could be density, or specific energy, or momentum per unit volume.
Louisiana Tech University
Ruston, LA 71272

18. Reynolds Transport Theorem: Momentum
If we are concerned with the entity “mass,” then the “property” is mass per unit volume, i.e. density.
Increase of momentum within the volume.
Production of momentum within the volume
Flux of momentum through the surface of the volume
Momentum can be produced by:
External Forces.
Louisiana Tech University
Ruston, LA 71272

19. Mass Conservation in an Alveolus
Density remains constant, but mass increases because the control volume (the alveolus) increases in size. Thus, the limits of the integration change with time.
Term 1: There is no production of mass.
Term 2: Density is constant, but the control volume is growing in time, so this term is positive.
Term 3: Flow of air is into the alveolus at the inlet, so this term is negative and cancels Term 2.
Control Volume (CV)
Control Surface CS
Louisiana Tech University
Ruston, LA 71272

20. Vector and Tensor Analysis
In the material derivative in Gibbs notation, we introduced some new mathematical operators
Gradient
In Cartesian, cylindrical, and spherical coordinates respectively:
What is this operation?
Louisiana Tech University
Ruston, LA 71272

21. Coordinate Systems Cartesian Cylindrical Spherical
What is an area element in each system?
What is a volume element in each system?
Louisiana Tech University
Ruston, LA 71272

22. Momentum Equation Navier-Stokes
General Form (varying density and viscosity)
Louisiana Tech University
Ruston, LA 71272

23. Momentum Equation
Be able to translate each vector term into its components. E.g.
Be able to state which terms are zero, given symmetry conditions. E.g. what does “no velocity in the radial direction” mean mathematically. What does “no changes in velocity with respect to the q direction” mean mathematically?
Louisiana Tech University
Ruston, LA 71272

24. Continuity Equation Compressible Incompressible
Louisiana Tech University
Ruston, LA 71272

25. Last Word of Advice Always check your units. Louisiana Tech University
Ruston, LA 71272