1. KX-NS1000 Basic Specification
Document for Technical and Sales Training
KX-NS1000 Basic Specification
August 22, 2014
Panasonic System Networks PBX SE team
This document explains basic specification of KX-NS1000 version 4.1. It is recommended to know basic specification of KX-NS small PBX before reading this document. Specifications are subject to change without notice.

2. 100 % Feature transparency like TDE600 and TDE620
1. Introduction
KX-NS1000 is bigger capacity model of KX-NS PBX series. KX-NS1000 supports 1,000 extensions. 1,000 IP phone or 1,000 Digital PT or 1,000 SLT or 1,000 mixture KX-NS1000 supports lots of built-in solution. Voice Mail, Unified Message, Recording, Call center, Unified Communication, Mobility, Conference, One-look networking and so on
KX-NS8188 E1 adapter KX-NS8290 PRI adapter
Built-in Solution
KX-NS1000 Master
KX-NS1000 Slave
KX-NS0130
KX-TDE620 etc
KX-NS0130
Max. 16 KX-NS1000
IP Network
1,000 Extension
KX-DT w/ SLT KX-DT KX-T7xxx SLT DSS Console
KX-NT KX-UT Other SIP SIP Phone Softphone
100 % Feature transparency like TDE600 and TDE620 2

3. 2. Feature Difference
KX-NS small PBX and KX-NS1000 have same feature basically like KX-NCP and KX-TDE. Feature difference is as follows.
Feature
KX-NS small PBX
KX-NS1000
One-look network
Yes (as slave)
Yes
Trunk Adapter : KX-NS8188/8290
See “1. NSx00 Basic Spec 2014-xxxx.pptx.”
RS232 port
No but SMDR through LAN
LAN port
10/100 Base TX
10/100/1000
WAN port No
MNT port
No but USB port with adapter
Fax to
Sensor to
Yes (Version 4.1)
Simple VM
Yes (*)
Modem : KX-TDA0196
PT Program
40,000 calls SMDR by SD .　
(*) These features are not available when KX-NS small PBX is connected with KX-NS1000 by one-look network.

4. 3. Table of Contents Chapter Contents 1 Basic configuration 2
Stacking card / One-look networking 3
Trunk adapter (E1/PRI) 4
WAN (Built-in Router) 5
Activation key 6
Capacity (Review & Conditions) 4

5. Chapter 1 Basic Configuration

6. 13. KX-NS1000 Main Unit Front View Back View A B C D E F G H I J M N P
3 Indicator for (1) System (2) Battery (3) Master / Slave B
Default Switch C
USB Port D
LAN port for maintenance PC (*) E
LAN Port for customer network F
WAN Port G
MOH Port H
Pager Port I
Doorphone Slot J
Free Slot M
Power Switch N
Earth Terminal O
AC Inlet P
Clip Hole for AC cable Q
MPR ID R
RS-232C Port A B C D E F G H I J
Back View M N P Q R
(*) D is independent from E. D is useful when PC for maintenance is not allowed to connect to customer’s network D and E for TDE/NCP were for same network. O

7. 14. Optional Cards on Mother Board
Two DSP can be installed.
Hot swap is not available.

8. 15. Optional Cards on Front
2 analogue trunk ports with Caller ID (FSK/FSK with Call Waiting Caller ID /DTMF). One port is a power failure transfer (PFT) port. 2 extension ports with Caller ID (FSK) for SLTs.
Hot swap is not available.

9. Chapter 2 Stacking Card One-look Network

10. 100 % Feature transparency like TDE600 and TDE620
21. Stacking Card
When customer needs lots of analog SLT, digital PT, analog CO, PRI and so on, KX-NS1000 with stacking card KX-NS0130 is useful. - KX-TDA , KX-TDE or KX-NCP works as slave unit. - 2 slave units are supported with one KX-NS1000 by one KX-NS KX-NS0131/0132 is installed to slave unit instead of MPR or BUS card. - KX-TDA(E)620 cannot be connected with KX-TDA(E)600 by BUS card.
Built-in Solution
KX-NS0130
Stacking card for NS1000
KX-NS0131
Stacking card for NCP
KX-NS0132
Stacking card for TDA/TDE
KX-NS1000
KX-NS0130
KX-TDE620 etc
DSP
IP Network
640 Extension
KX-DT w/ SLT DSS Console
KX-NT KX-UT Other SIP SIP Phone Softphone
100 % Feature transparency like TDE600 and TDE620 10

11. 100 % Feature transparency like TDE600 and TDE620
22. One-look Networking
A maximum of 12 KX-TDA/TDE/NCP and 16 KX-NS1000 can be connected for the entire One-look Network for 1,000 extensions. One-look networking is similar to TDE600-TDE620 connection KX-NS1000 master works like KX-TDE600. Other units work like KX-TDE All programming is available through KX-NS1000 master like KX-TDE600. Activation key : KX-NSN001 is required for each KX-NS PBX.
Max. 16 KX-NS1000
Built-in Solution
KX-NS1000 Master
KX-NS1000 Slave
KX-NS0130
KX-TDE620 etc
DSP
DSP
KX-NS0130
IP Network
Max. 12 KX-TDA/TDE/NCP
1,000 Extension
KX-DT w/ SLT KX-DT KX-T7xxx SLT DSS Console
KX-NT KX-UT Other SIP SIP Phone Softphone
100 % Feature transparency like TDE600 and TDE620
Maximum of KX-TDA/TDE/NCP was 8 for KX-NS1000 version 4.0 or before. 11

12. 23. One-look Networking with KX-NS small PBX
A maximum of 15 KX-NS small PBX also can be connected for the entire One-look Network as slave PBX. Master PBX should be KX-NS Activation key : KX-NSN001 is required for each PBX. Hardware : DSP such as KX-NS5110 is required because VoIP is used for connection.
(A) Max. 12 KX-TDA/TDE/NCP
(B) Max. 24 KX-NS320 KX-NS520 KX-NS720
KX-NS1000
DSP
KX-NS small PBX
KX-NS0130
DSP
IP Network
(C) KX-NS1000 master + 15 KX-NS1000 or KX-NS small PBX
DSP
Max. 1,000 Extension
(A)+(B) Total
TDA/TDE/NCP 1 2 3 4 5 6 7 8 9 10 11 12
NSx20 24 22 20 18 16 14
KX-NS300 : KX-NSF990 AK and SD card such as KX-NS3134 are also required. KX-NS700 : KX-NSF991 AK is also required.
KX-NS small PBX cannot be master (including back-up master) because not enough CPU. 12

13. 100 % Feature transparency
24. Upgrade from QSIG
When customer is using KX-TDA/TDE/NCP with Q-SIG, KX-NS1000 with one-look networking is useful for more features such as paging.
IP Network
KX-TDE620
Stacking
Stacking
KX-TDE600
KX-TDE620
KX-TDE600
KX-NCP
Max. 8 PBXs
IP Network
Stacking
Stacking
KX-NCP
Stacking
QSIG
KX-DT KX-DT KX-DT
KX-DT KX-DT KX-DT
Paging
Paging
Paging
100 % Feature transparency 13

14. Chapter 4 WAN (Built-in Router)

15. 41. WAN (Built-in Router)
WAN (Built-in Router) is supported from KX-NS1000 version 3. Hardware for WAN is available since version 1 mass production. Activation key : KX-NSN101 is required.
One internet line can be used for both PC and VoIP.
IP Network
WAN Router
Port Fwd
LAN for Maintenance (Default)
LAN
LAN (Customer’s network) (Default)
When customer wants to add one more internet for VoIP (Extension or Trunk), Add one more router.
IP Network
IP Network
Or use built-in router. Port Fwd is not required.
Port Fwd
WAN Router
WAN
WAN
Router
LAN
LAN 15

16. 42. Built-in VPN
WAN / Built-in Router can support VPN (IP-SEC) feature also. VPN is required if one-kook network is configured using built-in router. Activation key : KX-NSN216 is required. (KX-NSN101 is also required.) One KX-NSN216 supports 16 VPN connection. Max. two AKs can be supported for 32 VPN connection. IP phone also can be connected using VPN for secured communication instead of MRG feature.
Easy Installation even for VPN by Panasonic technology “VPSS”.
IP Network
External VPN Router
VPN
VPN
VPN
Router
Router
Router 16

17. Chapter 5 Activation Key

18. 51. Activation key only for KX-NS1000
Following activation key is only for KX-NS1000. 18

19. 52. Activation Key for Expansion
Following activation key was added from KX-NS1000 version 3.
These AK are required for each master and slave PBX.
Model Name
Feature
Maximum
Description
KX-NSX910
Expansion AK
from NSM005
1 AK
IP phone Capacity is increased to 100ports
KX-NSX930
from NSM010
IP phone Capacity is increased to 300ports
KX-NSX999
from NSM030
IP phone Capacity is increased to 640ports 30 50
100
300
640
IP phone
Pre-installed
NSM005
NSX910
NSX930
NSX999
NSM010
NSX930
NSX999
NSM030
NSX999
NSM099
60days free trial is NOT available. 19

20. 53. Pre-installed Activation Key
Following features are available without buying activation key and without expiration.
IP Extension for KX-UT and KX-NT hardware phone : 8ch - Not for KX-NT700 and KX-NT based software phone - Not for 3rd party SIP phone => Easy to sell Panasonic KX-UT and KX-NT
UM (Built-in KX-TVM) : 2 ch
CA Basic (Built-in server / External server) : All users 20

21. Chapter 6 Capacity (Review and Conditions)

22. 61. Capacity - Summary Capacity is as follows. Line NS1000 x 1
NS1000 x 3 to 16
Trunk
256
256 x 2
600
Legacy
IP incl E1/PRI adapter
SIP incl PRI Public mode
H.323 incl PRI QSIG mode 48 96
Extension
640
1000
Digital PT / Analog PT / SLT
480 SLT (*1) 512 DPT (*2) IP
(*1) 24SLT x 10 by TDE620 x 2 for example (*2) 256 DPT including DXDP by TDE620 x 2 for example Capacity is occupied when hardware card and virtual IP card are installed, even if phone is not connected actually. For example, one DLC16 occupies 32-ch including Digital XDP. 22

23. 63. Capacity - KX-NT
KX-NT capacity for one unit of KX-NS1000 can be increased. Type 1 or Type 2 can be selected after default clear.
Type 1 (Default)
Stand Alone
One-look IP
640
1000
IP-PT (KX-NT series)
256
SIP
SIP Phone
KX-UT series
Type 2
Stand Alone
One-look IP
640
1000
IP-PT (KX-NT series)
SIP
256
SIP Phone
KX-UT series
Type 3 is also available to increase H.323 ch. : 128 ch for NS or more unit But capacity of IP extension reduces. See Installation manual for details. 23

24. 64. Capacity - Conditions
One VM channel reduces 10-port extension capacity of master PBX because CPU of master PBX needs more power for VM. - Default 2-ch does not reduce this. - Extension capacity of slave PBX does not reduce, even if slave PBX has VM because CPU of slave PBX is not so busy.
Total 1000 extensions
Master PBX
Slave PBX VM VM
VM (ch)
Extension
Default 2
640
2 + 2
620
2 + 4
600 :
2 + 22
420
VM (ch)
Extension
Default 2
640
2 + 2
2 + 4 :
2 + 22 24

25. 66. DSP Configuration Tool
Capacity of DSP can be confirmed using programming tool without PBX before installtion. (Off-line mode) 25

26. 67. DSP Booking
DSP can be booked for more important purpose by programming.
<Above example> 3ch OGM(DISA) can be used always. 4 or more ch OGM(DISA) can be used from “Free resources”. 26

27. 68. DSP Report
DSP report is supported. 27

28. Thank you !

29. Revision
Date
No.
Change
Aug 22
All
First release 29