1. Ch 16. Wireless WANs

2. 16.1 Cellular Telephony Designed to provide communication between two “moving” units – To track moving units (mobile station; MS), service area is divided into small regions called cells – Each cell is controlled by network station called the base station (BS)

3. Frequency-Reuse Cell size depends on the population of the area – High-density areas require smaller cells Frequency reuse – The set of available frequencies is limited – Neighboring cells cannot use the same set of frequencies due to wireless interference near boundary – Number of cells for a frequency reuse pattern  Reuse factor

4. Basic Operations Transmitting – MS (using a setup channel)  Closest BS  MSC (Mobile Switching Center)  Telephone central office  If the callee is available, assign a voice channel Receiving – Telephone central office  MSC (search for MS by paging)  BS  MS  If answers, assign a voice channel Handoff – If MS moves from one cell to another, MSC seeks a new cell that better accommodates the communication of the MS – Hard handoff – one BS-MS connection at any time – Soft handoff – allow two BS-MS connections when a handoff occurs Roaming: extension of coverage of a service provider using other providers’ service

5. First Generation Designed for voice communication Example: Advanced Mobile Phone System (AMPS) – North America standard for analog cellular system – Unlicensed ISM 800 MHz band – Two separate analog channels

6. AMPS  FM and FSK (frequency shift keying) modulation

7. Second Generation Designed for digitized voice Digital AMPS (D-AMPS) – Backward compatible with AMPS – Same band as AMPS – PCM modulation with TDMA – FDMA

8. GSM Global System for Mobile Communication (GSM) – European standard – Two 25 MHz bands for duplex communications

9. GSM TDMA – FDMA Channel data (bit) rate = (1/120ms) x 26 x 8 x 156.25 = 270.8kbps In Gaussian minimum-shift keying, the signal to be modulated onto the carrier is first smoothed with a Gaussian low-pass filter prior to being fed to a frequency modulator, which greatly reduces the interference to neighboring channels

10. IS-95 CDMA CSMA/DSSS and FDMA Two 25 MHz bands for duplex communications Forward transmission (BS  MS) – Synchronization is required for CDMA – use GPS (will see later) Electronic serial number

11. IS-95 CDMA 64 (forward) channels – Channel 0 is a pilot channel for synchronization Bit synchronization, serves as a phase reference for demodulation; Allows the mobile station to compare the signal strength of neighboring bases for handoff decisions. – Channel 32 gives system information to MS – Channels 1 to 7 are used for paging, to send messages to one or more mobile stations. – Other channels are for data traffic

12. Reverse transmission Reverse transmission (MS  BS) – DSSS (direct sequence spread spectrum) instead of CDMA – Normally 94 reverse channels (62 voice chs.) Soft handoff; frequency reuse factor = 1

13. Frequency Reuse Factor SystemReuse Factor AMPS (1G)7 D-AMPS (2G)7 GSM (2G)3 CDMA (2G)1

14. Third Generation Designed to provide both digital “data and voice” – Comparable voice quality to the existing telephone net. – Data rate of 144 Kbps for moving vehicles, 384 Kbps for pedestrians, 2 Mbps for stationary users – Support for packet- and circuit-switched data service – A band of 2 GHz with bandwidth of 2 MHz – Interface to the Internet European; W-CDMA North America; CDMA-2000 IMT-2000

15. 16.2 Satellite Networks Orbits – Time required to make a complete trip around the Earth is determined by the distance of the satellite from the center of the Earth (Kepler’s law) Geostationary Earth Orbit Medium Earth Orbit Low Earth Orbit

16. Geostationary Earth Orbit (GEO) Satellites move at the speed of Earth’s rotation – Altitude of satellite is 35,786 Km

17. Medium-Earth-Orbit (MEO) Global Positioning System (GPS) – Four satellites are visible from any point on Earth Trilateration is used to find a location – Three satellites are sufficient to locate a land unit by measuring distance from each satellite – Four satellites can be used when there is a clock offset between satellites and the land unit (Read the textbook, p 483) Applications of GPS – Military purpose, car navigation, clock synchronization of IS-95 CDMA cellular system

18. Low-Earth-Orbit (LEO) Cellular-like service using low-orbit satellites Iridium – Aim for providing direct worldwide communication using handheld terminals Globalstar Teledesic – Aim for providing fiber-optic-like communication (broadband channels, low error rate, low delay) Intersatellite link User mobile link Gateway link 66 satellite network 12 orbits, 288 satellite network

19. Homework Exercise – 19, 20, 26