Download presentation
1
Connectors & Cables © D. J. McMahon rev
2
1/4” TRS connectors – (Tip, Ring, Shield) or 1/4” ‘Phone Plug’
Usually for audio or low-voltage signal applications Tip Ring Shield (usually ground)
3
3.5mm TRS connectors --
4
TRS connector comparison 3.5 mm 1/4” 2.5 mm “sub-mini”
6
Coaxial power connectors --
or “Barrel Connectors” Used almost entirely for power connection from AC-DC adapters for low-power, low voltage devices. Over 20 variants on the same design, set by the Electronics Industry Association of Japan (EIAJ).
7
Typical variants -- 2.35 mm 3.00 mm 4.75 mm 5.50 mm
8
Banana plugs -- .75” spacing
9
D-subminiature connectors –
Most commonly 9-, 15-, and 25-pin types pin HD for VGA connections.
10
Phono Plug or ‘RCA Connector’
11
Deutsche Institut für Normung
DIN Connectors: Deutsche Institut für Normung Used in a large variety of analog, digital, and computer applications DIN: mm diameter: Mini-DIN: mm diameter:
12
S-Video (or Y/C) Connector --
( 4-pin Mini-DIN )
14
Multi-pin ‘Cannon’ connectors --
ITT-Cannon Corp. many applications
15
Molex© connectors --
19
Jones Connectors (Cinch-Jones) --
Preferred for low voltage, high current signals
20
Lemo Connectors – High density, low voltage; very robust
22
Lemo variants -
23
XLR connectors – Audio applications - very robust
( Cannon Corp: X-Type, Locking, Rubberized insulation ) Audio applications very robust
24
HDMI connector -- ( High Density Media Interface )
25
DVI connectors – ( Digital Visual Interface )
26
DVI connector pin-outs:
27
Coaxial Cable --
28
Coaxial Cable --
29
‘Characteristic Impedance’ for coax (Z0) –
A complex number with a resistive and reactive component. It is a function of the frequency of the applied signal, and is unrelated to length. The characteristic impedance of any cable is directly determined by the conductor sizes, the spacing between them, and the type of insulation used. Most coaxial cables have an impedance of 50 or 75 Ohms at high frequencies. where R is the resistance per unit length, L is the inductance per unit length, G is the conductance of the dielectric per unit length, C is the capacitance per unit length, j is the imaginary unit ω is the angular frequency 2πF
30
In order to have maximum signal transfer, the impedance of a coax line
should match that of the devices it connects. Video signals, cable TV, closed-circuit TV, etc all have a 75Ω impedance. RG6, RG79, and RG179 are most often used for video, depending on the type of signal, the distance, power, etc.
32
F-connectors – Video - almost exclusively for cable TV
33
BNC Connector (Bayonet Neill-Concelman)
Widely used for RF & video applications
35
Attaching a BNC – Read the instructions !
37
BNC’s on RG-179 coax
38
Various BNC adapters --
‘Barrel’ connectors for BNC
39
UHF connectors for coaxial cable –
PL-259 SO-329 RF applications - esp radio at medium to high power
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.