1. MicroTouch Touchscreen Integration Tips and Techniques MicroTouch On the Move Paul Hatin & Mark Roberts

2. Touch Sensor Construction Glass Panel Anti-Glare Conductive Touch Coating ClearTek Overcoat Rear Shield Coating Electrodes n Glass panel n Anti-Glare n Touch coatings n Front, rear n Electrodes n ClearTek Overcoat

3. MicroTouch Capacitive Sensor Technology

4. MicroTouch Controller Technology Power –+12 volts supplied through orange wire Touch working –Tap the Touchscreen, LED should flash Communications with System –Power on system, should find the controller –If not, turn power off –unplug the Touchscreen –power back up

5. Materials and Tools Recommended Materials –Double Sided Tape (touchscreen - display) 3M 4416 (1/16” thick) 8 pieces (1.5” long) 3M 4408 (1/8” thick) 8 pieces (1.5”long) –Closed cell single sided Gasket (bezel - touchscreen) Volara 2AF Epilon FR –Cloth Tape Ideal Brand Therm-X No. 724 Tools –Isopropyl Alcohol –Lint free cloth –X-acto Knife

6. Removing the Touchscreen Peel away gap tape Use X-acto knife to cut foam tape from top, left, right sides from the outside edge Lean Touchscreen forward & cut bottom tape from between Touchscreen and Display.

7. Preparing Display & Touchscreen Use Isopropyl Alcohol and soft lint free cloth Clean the surface of the Display Clean the inside surface of the Touchscreen

8. Alignment of the Touchscreen Align the Touchscreen both horizontally and vertically with the tube/LCD

9. Cover the air gap Use the Black Cloth tape Cover the perimeter of the Touchscreen fully covering the space between the Touchscreen and Display

10. Preparing Power for the Controller Orange - +12v, 60ma max, 47 ma typ, 400 mv max ripple Gray - Power Supply Ground Green - Chassis Ground, as short as possible Gray/Green - Can be combined to Chassis Ground