1. Side view of generator

2. Close up of unused grounding pad - gives provisions for mounting the absorber

3. Overview From N looking S From W looking E View From top Grounding pad

4. Main bar Hole centers spaced 3.25” horizontally, 1.875” vertically (to match holes in generator) Bottom hole centers 1.25” from bottom of plate. Note, it would be nice to add 4th row of bolts IF we can mount it without interference on the west side of the plate (toward outboard end of generator) 1.25” 1” 15” 35” 12” Plate thickness: 1” Plate material: steel Slot used for mounting weight bar to main bar

5. Weight Bar 12” 6” Weight bar is 1” thick. These hole sfor bolt to attach weight bar to main bar slot (nut and bolt) These holes are tapped to mount fine tune blocks to weight bar using 1.75” long bolt

6. Fine tune blocks (2) 6” Fine tune blocks are 1” thick. They will be mounted to the tapped holes in the weight bar using a 1.75” bolt through fine tune block slot

7. Spacer block (If needed) 12” 6” Spacer bar to mount between the main bar and the generator. Holes drilled in same pattern as main bar Spacer bar thickness selected to provide approx 1” clearance between main bar and lifting eye on stator. Maybe 1/2” thick.