1. CIT 673 Created by Suriyong1 Micro controller hardware architechture

2. CIT 673 Created by Suriyong2 Scope Hardware Diagram Operating Mode Architecture installing clock external memory attachment

3. CIT 673 Created by Suriyong3 Pin configuration MCS51Core CPU Atmel 89S8252

4. CIT 673 Created by Suriyong4 Pins Address/Port: High address/P2: 8 pins A8-A15 or Port 2 Address/Data/Port: Low address/Data/P0 8 pins A0-A7/D0-D7/Port 0 Port: port 1 8 bits Signal pin ALE: Address Latch Enable : active high, signal to express that the signal is low address at P0 PSEN: Program Strobe Enable: active low, signal when access to external program memory EA: External Access: active low, signal to control the CPU to access the external memory RST: CPU Reset input Signal/Alternate function port pin : port 3 WR: Write signal to external data RD: Read signal to external data TXD: Transmit Data, serial communication RXD: Receive Data, serial communication External interrupt source and signal Clock : pin X1 and X2 Power Supply : VCC:GND

5. CIT 673 Created by Suriyong5

6. 6 Operating Mode 1 chip mode operating use only CPU and its SFR Multi-chip mode when extend or need more peripherals such as extend external RAM, more I/O

7. CIT 673 Created by Suriyong7 Architecture busses address bus data bus ports registers register that control CPU operating clock signals hardware connection Address space memory address decoding External Input/output address decoding and interfacing Interrupt Hardware architechture

8. CIT 673 Created by Suriyong8 BUS Address BUS 16 bit able to decode of 65536 address Use alternate function of P2 as high address bus P0 as low address bus and multiplex with data bus use Address Latch Enable (ALE) signal as multiplex signal need Latching IC : 74LS373 to latch the low address Data bus 8 bit alternate function of P0 multiplex with low address bus first as address, next as data

9. CIT 673 Created by Suriyong9 External data and program memory accessing when external memory is needed use Program Strobe ENable (PSEN) to signal to decode the memory when PSEN low: program memory is accessed and data is get after Read (RD) signal is active high: data memory is accessed and data is get or write after RD or WR signal

10. CIT 673 Created by Suriyong10 External memory diagram

11. CIT 673 Created by Suriyong11 CPU Register Unable to manipulate directly PC: Program Counter Contain the address of the code ALU: Arithmetic Logical Unit the calculation zone