1. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 1 Review of draft-ietf-gsmp-04 Avri Doria, Nokia Fiffi Hellstrand, Nortel Networks Kenneth Sundell, Nortel Networks Tom Worster, Ennovate Networks Adelaide AU Thursday 30 March, 2000

2. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 2 Changes from -02 Added list of contributors to document Ch 1 _ Introduction Minor wording changes Ch 2 - GSMP Encapsulations Encapsulation Information moved to draft-ietf-gsmp-encaps-00.txt Ch 3 - Common Defintions and Procedures Restructured to remove redundancy from following chapters, especially Ch 4 Added SubMessage Indicator, Count, and Message Length Moved Failure Response Messages to Appendix A Added description of label usage including description of TLV labels Note: Items in itallics are covered in more detail in later slides or presentations

3. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 3 Changes from -02……….cont'd Ch 4 - Connection Added Reservation ID Added Input Service Selector & Output Traffic Parameter Block Added Encapsulation Method Separated out ATM specific procedures Delete Port Message replaced by Delete Output Port and Delete Input Port Move Branch Message replaced by Move Output Branch Message and Move Input Branch Message Ch 5 - Reservation Messages Chapter Added Reservation Request Message Delete Reservation Message Delete All Reservation Message

4. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 4 Changes from -02……….cont'd Ch 6 - Management Added Flow Control Flags to Port Management Message Add Multipoint Query Label to Label Range message Add Disjoint label support to Label Range Message query and response Ch 7 - State and Statistics - no change Ch 8 - Configuration Added Max Reservation count to Switch Configuration Message Addition of port types; FR, MPLS, CES (E1, D1, E3, D3) Added Event Sequence Number and Event Flags to Port Configuration Message response Port Type specific Data Section expanded for additional port types

5. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 5 Changes from -02……….cont'd Ch 9 - Events ReturnReceipt flag added to force controller to acknowledge receipt of Alarm Added Adjacency Update Message Ch 10 - Service Model Addition of Circuit Emulation Service information Other traffics parameters added Ch 11 - Adjacency Message moved here Added Support for Multiple Controller Adjacency Ch 12 - Failure Response codes description updated and moved here. Appendix A - Summary of messages updated and moved from chapter 12 Appendix B - Added Assigned numbers

6. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 6 Labels Type Bit indicates whether a Short Label of TLV label was being used Short Labels - traditional GSMP 28 bit label field Addition of label type FR, MPLS, TLV Labels Stacked Labels Replaced E(xtended) designation for S bit to indicate Stacked Label Stacked Labels are treated as a single label All Labels in spec designated as: +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |T|S|x|x| Label | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ Removed all references to extended labels in the messages themselves. Any label can be a stacked label (indicated by S). T indicates whether label is short or TLV.

7. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 7 TLV Labels +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |T|S|x|x| Label Type | Label Length | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | | ~ Label Value ~ | | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ Label Type A 12-bit field indicating the type of label. Label Length A 16-bit field indicating the length of label in octets

8. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 8 TLV Label Types Defined TLV LabelType ATM Label0x100 FR Label0x101 MPLS Gen Label0x102 FEC Label0x103 DS3-DS1 Label0x200 E3-E1 Label0x201 Structured -DS1 Label0x202 Unstructured -DS1 Label0x203 Structured -E1 Label0x204 Unstructured -E1 Label0x205

9. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 9 Adaptation Method Adaptation Method The adaptation method is used to define the adaptation framing that may be in use when moving traffic from one port type to another port type; e.g. from a frame relay port to an ATM port. The content of this field is defined by the Opaque flag. If the Opaque flag is set, then this field is defined by the switch manufacturer and is not defined in this protocol. If the opaque flag is not set, the field is divided into two 12-bit fields as follows: +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |IQS|OQS|P|x|N|O| Input Adaptation | Output Adaptation | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ Adaptation Types: 0x100 PPP 0x200 FRF.5 0x201 FRF.8

10. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 10 Flow Control changes +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Event Flags | Flow Control Flags | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ Event Flags Field in the request message is used to reset the Event Flags in the switch port indicated by the Port field. Each Event Flag in a switch port corresponds to a type of Event message. When a switch port sends an Event message it sets the corresponding Event Flag on that port. Depending on the setting in the Flow Control Flag, a port is either subject to flow control or not. If it is subject to flow control then it is not permitted to send another Event message of the same type before the Event Flag has been reset. To reset an event flag, the Function field in the request message is set to "Reset Flags." For each bit that is set in the Event Flags field, the corresponding Event Flag in the switch port is reset.

11. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 11 Flow Control changes cont'd Flow Control Flags Field This flags in this field are used to indicate whether the flow control mechanism described in the Events Flag field is turned on or not. If the Flow Control Flag is on, then the flow control mechanism for that event on that port is activated. To toggle flow control, the Function field in the request message is set to "Reset Flags." For each bit that is set in the Flow Control Flags field, the flow control corresponding Event in the switch port is toggled.

12. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 12 Flow Control - example Trigger Event Flag Flow Control Flag Action t0 0 1 event 1 1 message sent event 1 1 no message sent Reset Event Flag 0 1 event 1 1 message sent event 1 1 no message sent Toggle Flow Control 1 0 event 1 0 message sent Toggle Flow Control 1 1 event 1 1 no message sent

13. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 13 Label Range Message +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Version | Message Type | Result | Code | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Partition ID | Transaction Identifier | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Port | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Port Session Number | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |Q|M|D|x| Range Count | Range Length | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | | ~ Label Data Block ~ | | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ Q - Query flag M - Multicast D - Disjoint Range

14. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 14 Label Range Message cont'd Each element of the Label Data Block has the following format: +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |T|S|V|x| Min Label | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |T|S|x x| Max Label | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Remaining Labels | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ V: VP Label The Label flag use is ATM port type specific.

15. © NOKIAMSF Paris drieft-ietf-grmp-04.PPT / 28 March, 2000/ ADo page: 15 Reservation Messages Reservations are hard state objects in the switch that can be created by the controller by sending a Reservation Request message. Each Reservation is uniquely identified by an identifying number called a Reservation ID. Reservation objects can be deleted with the Delete Reservation message or the Delete All Reservations message. A reservation object is also deleted when the Reservation is Deployed by specifying a Reservation ID in an Add Branch message. A Reservation object includes its Reservation ID plus all the switch state associated with a branch with the exception that the branch’s input label and/or output label may be unspecified. The switch established the maximum number of reservations it can store by setting the value of Max Reservations in the Switch Configuration response message. The switch indicates that it does not support reservations by setting Max Reservations to 0. Reservation Request Message = 70 Reservation Delete Message = 71 Delete All Reservations = 72