1. Infrared Remote Description Remote control distance ： About 5m Two modes: 1. Default control Mode( for all Panel) 2. Page control Mode ( for DLP using, which includes: [AC] page for air conditioner [AU] page for music

2. Infrared Remote Enable the panel to receive IR code Setup Panel’s IR function

3. Infrared Remote Default control Mode Default control mode Default Mode is used for controlling the Panels, and each key of the remote links with a key of the panel

4. Infrared Remote Page control Mode The LCD will show current page number in Page control Mode, and also can set to show/hide specific pages

5. Infrared Remote Mode switch: Default control Mode to Page control Mode 1. Keep pressing UP key 2 seconds till the digit flashes 3. Press up or down to select page 4. E.g., press UP to select page 2 5. Press any key from 1/3/5/7 to enable page2; Press any key from 2/4/6/8 to disenable page2. 6. Keep Pressing UP key for 2s to save the setting and exit 2. Press any key from 2/4/6/8, disenable the default mode.

6. 1.Keep Pressing down key 2S till digit flashes 2.Select a page number by up or down key ( e.g., page2) 3.Press any key from 1/3/5/7 4.Keep pressing 2s to save and exit( till LCD stop flashing), then page 2 will be the default page Set a page as default page Infrared Remote

7. 1.Press UP key 2s till LCD flashes 2.Press any key from 1/3/5/7 3.Press UP key 2s till flashing stop Mode switch: Page control Mode to Default control Mode

8. Infrared Remote Protocol shift 1. Press key1&4 at the same time for 2s to jump to the system setting page below: 2. Select “IR select” option (not shown in below old menu), the third LED will be on, Press any key of the remote to off the LED, then the DLP can be controlled by the remote. PS: The remote has 8 types of protocols, use key 1 to 8 to select. In case you got more than one IR remotes and don’t want to mess them up, then you can press key 1 of remote1 for 20 seconds till the characters on remote flicker to assign an ID “1” to remote1, press key 2 of the remote2….to assign an ID “2” to remote2…