Download presentation
Presentation is loading. Please wait.
Published byClifton Carter Modified over 9 years ago
1
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Recent work on pressure bias problem Lucio TORRISI Italian Met. Service CNMCA – Pratica di Mare (Rome) l.torrisi@meteoam.it
2
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Overview The pressure bias problem (RK/LF) Dynamics bottom boundary condition RK/LF comparison The pressure bias problem (domain size, model equation formulation) New reference atmosphere impact Heat source term in pressure equation Conclusion
3
10 th COSMO General Meeting, Krakow, 15-19 September 2008 - Runs using mostly COSMO V4.2+ - Domain dependent on grid spacing used - Objective verification of forecast parameters against European Temp/Synop network Configuration
4
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Pressure bias problem (1) This problem was pointed out in Torrisi (2005): “Sensitivity experiments with the Runge Kutta time integration scheme”, presentation at COSMO GM in Zurich 1) RK/LF core - Objective verification showed a difference in MSLP bias behaviour between 7km RK (red line) and LF (green line) runs. MSLP bias difference increases with forecast time. RK runs have a larger bias, typically positive, leading to a worse RMSE.
5
10 th COSMO General Meeting, Krakow, 15-19 September 2008 In COSMO model an extrapolated boundary condition for p*, which is based on the assumption of a constant vertical gradient at the lower boundary: Dynamic bottom boundary cond. = ke ’ +1 ke’
6
10 th COSMO General Meeting, Krakow, 15-19 September 2008 “Pressure Bias Problem” Blue:Old Bottom Boundary Cond. Red:Dynamic Bottom Boundary Cond. An improvement in RK core was obtained by the implementation of the Gassmann formulation (COSMO Newsletter No. 4) of the dynamic bottom boundary condition for metric pressure gradient term in equation for u- and v-component Dynamic bottom boundary cond.
7
10 th COSMO General Meeting, Krakow, 15-19 September 2008 7km RK/LF comparison
8
10 th COSMO General Meeting, Krakow, 15-19 September 2008 7km RK/LF comparison
9
10 th COSMO General Meeting, Krakow, 15-19 September 2008 7km RK/LF comparison
10
10 th COSMO General Meeting, Krakow, 15-19 September 2008 RK/LF comparison In summary: 2.8/7km: the results of the previous experiment (7km, winter period) show that RK and LF MSLP bias are almost the same, but small differences (depending on season, domain, location, etc) are still found (RK larger bias) 14 km: very big differences are found (RK has an increasing MSLP positive bias with forecast time) Other work has been done on RK core (change in metric term discretization, change in vertical average on half levels, etc), but no positive impact was found (in some cases slight negative impact!)
11
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Pressure bias problem (2) 2) Domain size - Objective verification showed a difference in MSLP bias behaviour in 7km RK (and LF) runs having a different domain size (smaller one - red line, larger one -green line). The larger domain, the greater MSLP bias
12
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Pressure bias problem (3) 3) Model formulation - Objective verification showed a difference in MSLP bias behaviour between 14km COSMO LF/RK (blue line) and HRM (red line) runs. HRM is the DWD regional hydrostatic model (LF time integration scheme) used in the CNMCA assimilation systems (3D-Var PSAS and LETKF). MSLP bias difference increases with forecast time (COSMO larger positive bias)
13
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Pressure bias problem The increase of the MSLP bias with forecast time is a characteristics of COSMO model runs and it does not seem dependent only on dynamical core (point 1). This behaviour is evident using very large domain size (point 2) and particularly clear using a 14 km grid spacing (point 3). The effects on the pressure bias of two changes in the model formulation will be addressed: - Zaengl (2008) proposed a new reference atmosphere to overcome the problem of limitation in vertical extent of the model domain using the default reference atmosphere - Gassmann and Herzog (2006) reconsidered the derivation of prognostic temperature and pressure equations to remove some inconsistencies in the formulation of these equations
14
10 th COSMO General Meeting, Krakow, 15-19 September 2008 New reference atmosphere Introducing a reference state reduces the computational error in the calculation of pressure gradient terms in the equation of motion for not too large deviations of pressure from reference pressure. The default reference atmosphere of COSMO model is based on assuming a constant rate of increase of temperature with the logarithm of pressure dT/d(logp)=const. The lapse rate dT/dz becomes more and more negative with height limiting the possible vertical extent of the model domain (about 29km with the current default settings).
15
10 th COSMO General Meeting, Krakow, 15-19 September 2008 New reference atmosphere Zaengl (2008) implemented a new reference atmosphere based on a temperature profile which starts with a prescribed sea-level temperature and exponentially approaches an isothermal stratosphere. In this way there is no limitation on vertical extent of model domain.
16
10 th COSMO General Meeting, Krakow, 15-19 September 2008 New reference atmosphere 7 km
17
10 th COSMO General Meeting, Krakow, 15-19 September 2008 New reference atmosphere 14 km
18
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Pressure bias increase has been found in experiments using a coarser resolution (14 km) and also enlarging the size of the domain (7km). This could be an indication of some inconsistencies in the formulation of T/p budget equ. Heat source term in p equation Turbulent heat and Radiaton flux Diabatic heating due to cloud microphysical sources Turbulent flux for water constituents Turbulent flux for water constituents and Precipitation (gravitational diffusion) fluxes Cloud heat sources
19
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p equation An adequate approximation of pressure equation is to neglect the moisture source term Q M Dudhia (1993) has pointed out, that the neglection of diabatic heating term (Q T ) in the pressure equation might be even advantageous for models with a rigid upper boundary.
20
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p equation The heat and moisture terms (Q T and Q M ) are neglected in the COSMO model pressure equation Gassmann and Herzog (2006) in their presentation at LM-User Meeting “reconsidered the derivation of prognostic temperature and pressure equations in the LM” “1. In pressure equation heat and moisture source terms neglected 2. dp/dt in T-equation eliminated after neglecting these terms 3. Formal addition of moist convection tendency, computational mixing, lateral and upper boundary relaxation terms in T/p equ.” “This operation is equivalent to the application of a wrong continuity equation producing a mass deficiency ………………………..” “The way to come to this result is wrong and leads to insufficient equations !”.
21
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p equation They concluded: “- …… - It is shown that the well-known heat- and moisture source/sink terms are necessary to be taken into account in the pressure equation in order to allow in small-scale simulations the direct influence of thermal and moisture effects on the pressure field - and so on the wind field too. - Ignoring these terms or having some inconsistent approximation of them in the pressure equation is equivalent to a hidden mass budget error in the model. - Furthermore, even the heating terms in the final prognostic temperature equation appear to be not correct, if for the elimination of the individual pressure tendency a pressure equation is applied where the diabatic terms are already ignored or incomplete. - …..” From this work the motivation to investigate in real cases the effects of the heat source term in pressure equation (moisture source term neglected)
22
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p equation These new terms were added in the p/T equations and the saturation adjustment scheme was consistently adapt to the changes in p/T equations. The reformulated equations are:
23
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p equation
24
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p equation 2.8 km RK+Qh_PERK 2.8 km
25
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p equation
26
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p equation 2.8 km RK+Qh_PERK
27
10 th COSMO General Meeting, Krakow, 15-19 September 2008 RK+Qh_PE RK Heat source term in p equation 7 km
28
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p equation In a few real cases (winter) with a 7 km grid spacing: –domain averaged near upper boundary temperature is not significant changed (very very … slightly decreased) –domain averaged total precipitation is slightly decreased –MSLP bias is reduced (except for 12-15 UTC) LF RK 7 km
29
10 th COSMO General Meeting, Krakow, 15-19 September 2008 LF RK 7 km Heat source term in p equation
30
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p equation 7 km LF
31
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p-equation 7 km In a summer period the effect of the heat source term on pressure bias seems to be different from the winter period results previously shown: –MSLP bias is reduced from 21 to 06 UTC and increased from 9-15 UTC
32
10 th COSMO General Meeting, Krakow, 15-19 September 2008 LF+Qh_PE Heat source term in p equation 14 km LF
33
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p-equation 14 km
34
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Heat source term in p-equation 14 km
35
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Pressure bias problem Other work has been done (divergenge and pressure gradient in conservation form, Gassmann time splitting scheme, etc), but no positive impact was found Impact of the new reference atmosphere on the pressure bias is very clear at 14km, but it quickly decreases with increasing resolution Impact of heat source in pressure equation on the pressure bias is apparent in 14 km runs. The improvement is not general using a 7 km grid spacing (slight deterioration around 12 UTC). Two runs with 2.8 km show an enhancement of maximum of precipitation. More work is needed!
36
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Conclusion The pressure bias problem is typical of COSMO model (not only of RK core!) The pressure bias problem seems to be mainly related to the model equation formulation. The use of prognostic p equation does not guarantee an exact mass conservation, which is equivalent to introduce artificial sources or sinks in the continuity equation Problems arise in applications such as data assimilation systems, where the pressure accuracy is important A more conservative dynamical core is needed for COSMO model
37
10 th COSMO General Meeting, Krakow, 15-19 September 2008 Thank you for your attention!
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.