1. BACHELORETTE PURSUIT

2. SUPPLIES

3. 1)A box to put your game in Any box will do. Just make sure your game board can fit inside. 2)Mod Podge $7.99 at Hobby Lobby but you can find smaller bottles that are Less expensive. 3)Small paint brush Any kind will do. 4)Player pieces These are up to you. I chose to use Miniature bunnies because I think they are super cute.. 5)A Small box to hold the player pieces Any little storage container works. I got this heart box from Hobby Lobby for $1.99 6)Envelopes for your cards Any envelope will do.

4. 7)Glitter paper $0.99 at Hobby Lobby. You’ll need the following colors: pink, black, red, and silver. 8)Colored paper $5 at Hobby Lobby. You’ll need the following colors: yellow, pink, blue, and green. 9)Circle paper pieces $1.99 at Hobby Lobby. 10)Square paper pieces $2.99 at Hobby Lobby 11)Markers

5. 12)Glue gun $2.99 at Hobby Lobby 13)A ruler 14)Scissors 15)And anything else you want to decorate your board game

6. D.I.Y. INSTRUCTIONS

7. STEP ONE Cut out a 10 x 10 square from your glitter paper. (one red, one silver, one black, and one pink)

8. STEP TWO (1) Print out the icons. (in print.doc). Cut them out and glue them to the circle pieces using mo podge. First apply the glue to the back of the icons. Second, place them on the circle paper and press down. Wait for 15 minutes. Lastly apply a top coat of the mod podge to the entire circle. (2) Decorate your end pieces. ----->

9. STEP THREE Using the hot glue gun, glue the circle pieces, and the end pieces to the game board.

10. STEP THREE cont. The end result should look like this -------> *The “winner” piece is not glued to the board. Each section (silver, pink, red, and black) are put on top of each other when the board is put up so that they will fit in the box.

11. STEP FOUR Now it’s time to make the cards. (1)Print out the cards in the print.doc you downloaded. Then cut them out. (2)Next, glue them to the colored paper using mod podge. Wait 15 minutes. (3)Cut the cards from the colored paper. Lastly apply a top coat with the mod podge. (2)

12. STEP FOUR cont. The end result should look like these ------->

13. STEP FIVE Decorate the envelopes. When your done, place the cards inside.

14. STEP SIX Print out the instructions from game_instructions document. Then place them in their envelope.

15. STEP SEVEN Almost done! Now its time to decorate the top of your box. This is what I did for mine ------->

16. STEP ONE Lastly, place everything in the box. (1) The game board (2) The player pieces (3) The envelops with the cards

17. YOUR DONE!!!