1. उद्यमेन हि सिद्ध्यन्ति
Four Day’s Workshop on “COMPUTATIONAL FLUID DYNAMICS Using ANSYS FLUENT 14.5”
AGENDA

2. Agenda – Day 1 CFD Pre-Processing
10: :30 Lecture 1 Basic Introduction of CFD
10: :00 Lecture 2 Steps follow in CFD Simulation
11: :30 Lecture 3 Introduction of ANSYS WB
11: :00 Lecture 4 GUI of ANSYS WB (Demo)
12: :30 TEA-BREAK
12: :00 Lecture 5 Geometry export in WB (Demo)
13: :00 Lecture 6 Meshing in WB (Demo)
14: :00 Workshop D wind tunnel for small car
15: : TEA-BREAK
15: :30 Workshop D pipe bend (mixing tee)
16: :00 Lecture 7 Introduction of ANSYS Fluent

3. Agenda – Day 2 CFD Solution & Post Processing
10: :30 Lecture 1 ANSYS FLUENT Demo-1
10: :00 Lecture 2 ANSYS FLUENT Demo-2
11: :30 Workshop 2.1 Car wind tunnel analysis
11: :00 Workshop Continue
12: :30 TEA-BREAK
12: :00 Lecture 3 Cell Zones and Boundary Conditions
13: :30 Lecture 4 Solver Settings
13: :00 Lecture 5 Post Processing
14: : TEA-BREAK
14: :30 Workshop mixing tee analysis
15: :30 Workshop 2.3 Electronic board cooling
16: :30 Review

4. Agenda – Day 3 CFD Advanced Topic
10: :30 Lecture 1 Turbulence Modeling
10: :00 Lecture 2 Heat Transfer
11: :00 Workshop 3.1 Turbulent Flow Behavior
12: :30 TEA-BREAK
12: :00 Lecture 3 Radiation Modelling
13: :30 Lecture 4 Multi-Phase Modeling
13: :00 Lecture 5 Virtual Data recorders
14: : TEA-BREAK
14: :30 Workshop 3.2 problem
15: :00 Lecture 6 UDF-Basics
16: :00 Lecture 7 Write First UDF
17: :00 Workshop 3.3 problem

5. Agenda – Day 4 CFD Advanced Topic
10: :30 Lecture 1 Solidification and Melting
10: :00 Lecture 2 Erosion Modeling
11: :00 Workshop 4.1 Continuous casting Modeling
12: :30 TEA-BREAK
12: :00 Lecture 3 Design Exploration using ANSYS WB
13: :30 Lecture 4 Direct Optimization
13: :00 Lecture 5 Design of Experiment
14: : TEA-BREAK
14: :30 Workshop 4.2 Optimization for Heat Pipe
15: :00 Workshop 4.3 DOE-Surface Response Methodology
16: :00 Lecture 7 Review
17: :00 Closing Ceremony