1. CircuitPro 3D 1.5

2. The outline worked with 5 mu alter beam compensation. But this type off defect was made in many places. I used the same faces in the old program on LDS machine All lines worked ok.

3. I tried to change the tool path. This type of change normally works but not this time.

4. The problem comes when trying to add or split a line Then I get error “Can’t create new line” In the old software on the LDS machine this happens quit often but it can be solved by restarting the program. In the office program the problem stays after restart. This time, testing the function to get the messages, end with program shut down.

5. Other problems I have also other problems that makes the work hard. When selecting lines for start of hatching it is nearly impossible to see if the line is picked or not. It is very easy to miss a small line with the consequence that I must start from beginning. The selected line needs to be highlighted in some way, new colour or thicker line. One problem is also that I must start from beginning. Could it be possible to edit hatching start, add or remove a missing line? Colours on surfaces and solids. In the tree you can change the appearance of a surface ore solid, new colour to easier se different faces. But all changes disappears after hiding or restart the work. It can’t be saved.

6. Wishes It should be good to have the possibility to reorder the faces in the tree to get easer work view. Hatching start line and alter beam compensation line is mixed into the faces in the tree. As it is now I can’t see any use for this lines, it would be better that they disappears. But if it had bin possible to edit them it could be good to have the under a separate folder or under folder to the face they are connected to. My way to solve the problem is to delete them.