1. Band Saw Information Andy Lyman

2. Uses of the band saw The band saw is used to make straight or curved cuts Wide blades are for straight cuts Narrow blades or for curved cuts

3. Tuning up the band saw Tensioning the blade- tighten the blade so that when you pluck it like a guitar it has a clear tone and not a dull thud. Next you should check the blade for deflection. Raise the guide all the way up and push sideways on the blade and make sure its not deflecting much. Tracking the blade-When the blade is tracking correctly it is running on the middle of the wheels. There is a knob above the upper wheel housing that controls this. Just spin the blade by hand and adjust the knob until the blade runs on the middle of the wheels.

4. Band Saw tune up continued… Square the blade and the table- Loosen the knobs that lock the table in place. Hold a small square on the table with its blade against the saw blade and then just square the table to the blade and lock it in place Setting the guides- move the guard up about halfway between the table and the top of the case and adjust it evenly with the guards as well.

5. Safety Tips Keep you hands clear of the table insert Keep your hands and fingers several inches from the side of the blade Do not reach across the saw line Keep your work area clean Never leave the machine operating unattended

6. Safety tips Don’t interrupt others while using power equipment Keep your attention on the job at hand and stay focused until the blade has stopped Do not cut round stock because it may roll back into the blade and cause an accident Maintain the stock flat on the table Keep all guards in place

7. Pictures guides

8. Band Saw