1. Connecting the cRIO to the 12 V power source and your computer
Use the following pictures, diagrams and instructions to correctly connect your cRIO so it can be imaged.

2. Connecting the power source to the power distribution board
All required wire gauges and a schematic layout of the PDB can be found here.
The other end of the power supply connects to the terminals of the PDB. Always cover the terminals with a non-conductive material
First connect the battery to the120A Circuit Breaker using the battery cables provided by first(6AWG).

3. Getting power from the PDB to the cRIO
Using 22 AWG wire or thicker, connect the power from the power distribution board to the see Rio as shown.

4. Connecting your computer to the cRIO
Using the crossover cable connect to see Rio to your driver station or laptop using the ethernet ports on both.
Crossover cables look like ethernet cables except for the wiring is a bit switched around. Make sure that you're using a crossover cable when you connect to cRIO to your computer before imaging your cRIO.
You are now ready to image your cRIO!