1. MOSAIC CONSTRUCTION

2. DIVIDE THE DESIGN INTO MOSAIC PIECES

3. PIECES SHOULD FIT TOGETHER, THE PIECES SHOULD NOT BE TOO BIG OR TOO SMALL.

4. WORKING MOSAIC DESIGN

5. USE WATERCOLOR MARKER TO COPY THE WORKING MOSAIC DESIGN

6. PLACE THE TRACING PAPER (THE SIDE THAT WAS DRAWN ON WITH THE MARKER) ONTO A SMOOTH SLAB.

7. PRESS WITH FINGERTIPS ON ALL OF THE MARKER LINES.

9. CUT OUT THE PIECES OF THE MOSAIC WITH A K-9 TOOL.

12. CRAFT THE PIECES THE EDGE PIECES NEED TO BE CRAFTED THE ENTIRE SIDE OF THE PIECE AS THEY WILL BE EDGE OF THE MOSAIC.

13. ALL PIECES NEED TO BE PUT TOGETHER.

14. STORE MOSAIC WITH THE PIECES TIGHTLY TOGETHER

15. TRANSFER DETAILS TO CUT OUT MOSAIC PIECES

16. LINE UP TRANSFER AND PIECES CAREFULLY

17. SO THE DESIGN GOES ON CLAY PROPERLY

18. CAREFULLY CARVE OUT FAUVE LINES

19. CLAY CRUMBS CAN BE BRUSHED OFF AS THE CLAY DRIES.

20. ALWAYS KEEP THE PIECES TOGETHER WHEN WORKING ON THEM, STORING THEM AND BISQUE FIRING THEM.

21. THIS MOSAIC IS CALLED POTTER AT THE WHEEL.