2. Slide 1 Welcome to SimELMO; 35MM Slide Edition! In this simulation you will learn to display individual photographic slides via your Elmo document camera. To begin turn the projector on via the control console at the lower right. Steve Bonham Center for Excellence in Teaching Georgia Southern University 2005

3. Slide 2 Now select the source to send to the projector; click the “Doc Cam” button on the console.

4. Slide 3 Flip the document camera’s power switch to on.

5. Slide 4 Press the lamp button twice to turn the base lamp on. Note that the main output light is now lit.

6. Slide 5 The upper lamps are on. Press the lamp button once again to turn the base lamp on.

7. Slide 6 Place the 35MM slide on the bed of the Elmo.

8. Slide 7 Place the 35MM slide on the bed of the Elmo.

9. Slide 8 Place the 35MM slide on the bed of the Elmo.

10. Slide 9 The lens is zoomed too wide. Tighten up (Tele).

11. Slide 10 Both lamps are off. Press the lamp button again to turn the upper lamp on.

12. Slide 11 You’ve switched on the upper lamps. Press the lamp button again to turn the base lamp on.

13. Slide 12 The lens is zoomed too wide. Tighten up (Tele).

14. Slide 13 Both lamps are off. Press the lamp button again to turn the upper lamp on.

15. Slide 14 You’ve switched on the upper lamps. Press the lamp button again to turn the base lamp on.

16. Slide 15 The lens is zoomed too wide. Tighten up (Tele).

17. Slide 16 Both lamps are off. Press the lamp button again to turn the upper lamp on.

18. Slide 17 You’ve switched on the upper lamps. Press the lamp button again to turn the base lamp on.

19. Slide 18 Great. Nice Job.

20. Slide 19 Both lamps are off. Press the lamp button again to turn the upper lamp on.

21. Slide 20 You’ve switched on the upper lamps. Press the lamp button again to turn the base lamp on.

22. Slide 21 Sorry. You’re not allowed to make changes on the control console in this simulation.