1. FEM/CFD thermo-mechanical analyses on IBL Mock-up A. Sciuccati

2. 18/02/2013TALENT Meeting – A. Sciuccati2 1 Introduction 2 Thermal analysis on the central part of the mock-up 3 Thermo-mechanical analysis on longitudinally deformation 4 Further studies Contents

3. 18/02/2013TALENT Meeting – A. Sciuccati3 The current ATLAS beam pipe will be extracted and replaced by the IBL package In order to study the IBL thermo-mechanical behavior and validate the beam pipe design, tests are performed on a mock-up of the IBL Mock-up differs from the IBL in some aspect (material, geometries, loads and boundary conditions) To establish a connection between the mock-up and the IBL package, thermo- mechanical simulations are essential Furthermore, instead of a locally evaluation of the interesting parameters also the complete field distribution can be obtained FEM/CFD modelization of the mock-up during the two more difficult phases (bake-out and service operation) will be performed An accurate numerical evaluation of the mock-up behavior allow the correct estimation of the thermo-mechanical load/deformation on the IBL Introduction

4. 18/02/2013TALENT Meeting – A. Sciuccati4 IBLM OCK -U P CENTRAL POSITION Thermal analysis on the central part of the IBL/Mock-up IBL/Mock Up comparison

5. 18/02/2013TALENT Meeting – A. Sciuccati5 Thermal analysis on the central part of the IBL/Mock-up IBL/Mock Up comparison IBLM OCK -U P CENTRAL POSITION

6. 18/02/2013TALENT Meeting – A. Sciuccati6 IBLMock-Up BP (aluminium) Heater (watlow silicon rubber) CENTRAL POSITION Kapton (polyimide) IPT (carbon fiber) Stave (aluminium) Glue (polyimide resin) Cooling pipe (stainless steel) IST (carbon fiber) IST (carbon fiber) Aluminium foil BP (beryllium) Heater (watlow silicon rubber) Kapton (polyimide) Aluminium foil IPT (carbon fiber) Stave Thermal analysis on the central part of the IBL/Mock-up IBL/Mock Up comparison

7. 18/02/2013TALENT Meeting – A. Sciuccati7 Thermal analysis on the central part of the IBL/Mock-up Bake-out phase 20°C Initial temperature = 20°C -40°C 250°C

8. 18/02/2013TALENT Meeting – A. Sciuccati8 Thermal analysis on the central part of the IBL/Mock-up Bake-out phase

9. 18/02/2013TALENT Meeting – A. Sciuccati9 Thermo-mechanical analysis on longitudinally deformation IBL/Mock Up comparison IBLM OCK -U P

10. 18/02/2013TALENT Meeting – A. Sciuccati10 Further studies IBL/Mock Up comparison Adapting of the IBL titanium support to the mock-up

11. THANK YOU FOR YOU ATTENTION