1. Milling Circles and Arcs and Milling with Canned Cycles 04/23/08

2. Review: Straight Lines Initiated by MOVE command

3. Circles Move the mill to the start of circle Put in arc mode with ARC.CW or ARC.CCW Specify center point Specify ARC

4. Arcs Move the mill to the start of circle Put in arc mode with ARC.CW or ARC.CCW Specify center point Specify end point

5. Arcs Z matters

6. Cylindrical Pockets Move the mill to the start Start pocket cycle with # sides and depth of each pass Specify center point and final depthSpecify center point and final depth Specify ARC

7. Pockets Move the mill to the start Start pocket cycle with # sides and depth of each pass Specify center point and final depth Specify end point

8. Cups Move the mill to the start Start cup cycle with # sides and depth of each pass Specify center point and final depthSpecify center point and final depth Specify ARC

9. Cups Move the mill to the start Start cup cycle with # sides and depth of each pass Specify center point and final depthSpecify center point and final depth Specify ARC

10. Partial Cups Move the mill to the start Start cup cycle with # sides and depth of each pass Specify center point and final depthSpecify center point and final depth Specify end point

11. Partial Cups Move the mill to the start Start cup cycle with # sides and depth of each pass Specify center point and final depthSpecify center point and final depth Specify end point

12. Drill Drills holes Begin with DRILL Specify points End with FINISH